answersLogoWhite

0


Best Answer
Copy

either your slave cylinder or master cylinder for the clutch has gone out

User Avatar

Wiki User

โˆ™ 2006-01-09 08:46:05
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: What does it mean when pressure is lost and your can not shift gears with a 5spd 2001 Ford Ranger 3.0 v6?
Write your answer...
Submit

Related Questions

How do you get the gear shift out of park 2001 ranger?

Depress the brake pedal to shift.


Does it take battery power to shift gears in a 2001 Chrysler Sebring?

Yes


Where is shift linkage located on 2001 Ford Ranger?

Middle corner near to fuel pipe....


What does blinking exclamation symbol on fuel mileage gage on 2001 Cougar mean?

Car sounds bogged down and hesitates to shift gears in lower two gears


Where is the electric shift control module for the transfer case on an 2001 ford ranger?

Behind the passenger side kick panel.


Where is the gear box for a 2001 ford ranger stick shift?

The gear box ( manual transmission ) is bolted to the rear of the engine


Toyota Echo 2001 loose gear shifter cannot shift gears?

Not really describing answer , but i would assume you shifter cables have broken


How many gears does a 2001 yz80 have?

Six gears


What are the plus and minus sign for they are located on the automatic gearshift on your 2001 dodge stratus?

You Stratus has what is called Auto-Stick. You can "manually" shift the gears by putting it in the +/- position and moving the shifter side to side.You Stratus has what is called Auto-Stick. You can "manually" shift the gears by putting it in the +/- position and moving the shifter side to side.


What is the oil pressure on 2001 Ford Ranger with 3.0 engine?

I'm not a mechanic / technician but I BELIEVE that is ( 40 to 60 PSI at 2,000 RPM ) for the oil pressure on a 3.0 liter V6 engine in a Ford Ranger


Why does your 2001 jeep wrangler fall out of gears when im driving it?

Check where your gear shift mounts to the top of the trans, when that plate gets loose this will happen a lot.


Where is the oil pressure switch for a 2001 Ford Ranger with 4.0L engine?

The oil pressure switch is under the power steering unit. The easiest access is from below the truck.


2001 intrepid will not change gears no sign of trans damage or slippage?

If the problem is that the shifter will not move you need to check the shift cable. If the shifter moves, but the trans doesn't shift; you need to check the fluid level and , the system for trouble codes.


How do you replace a water pump for a 2001 Ford Ranger?

how to replace water pump on 2001 ford ranger


2001 Aurora with a 3.5 V6 that won't shift into 4th gear All other gears shift smoothly The fluid is full and not burnt What could it be?

Can be Lower or high out putt sensors check it out with mechanic I had the same prblems with my 2003 dodge neon


At what speed should i shift gears on 2002 sportster 1200C?

I have a 2001 sporster. I usually shift at or alittle above 3000 rpm. Any thing lower puts my rpm at or under 2000 in the next higher gear, which makes my engine labor. I use my tac to shift and have never noticed the mph.


What are the release dates for The Best Ranger Challenge - 2001?

The Best Ranger Challenge - 2001 was released on: USA: 12 October 2001


Where is the electronic shift control module located on a 2001 Ford Ranger XLT?

it is found on the passenger side kick panel also called a 4x4 control module


What happens when your clutch fluid is empty on a 2001 maxima?

You will eventually lose clutch pedal pressure and the car will refuse to shift into gear.


Where is the fuel pressure regulator on a 2001 Ford Ranger XLT 3.0 V6?

It is attached to the end of the fuel rail. On 2001 f150 it is located at the back of the engine. Good luck getting at it.


Where is the shift solenoid located 2001 Ford Taurus?

where is the transmission shift solenoid on 2001 ford taurus


Can you put a 2001 3.0 ranger motor in a 2000 ranger?

not really


What is the clanking noise when you shift gears on a 2001 Chevy Tahoe?

Check universal joints if possible throw some grease on them and if it doesn't improve then most likely they have to be replaced.. Check universal joints


Cold cranking amps for a 2001 Ford Ranger?

How many cold cranking amp do a 2001 ford ranger needs?


Why for ranger 2001 v 6 don't have sparks?

why my 2001 for ranger v 6 dont have fire on the spark plugs