Want this question answered?
Turn your key to the run position without attempting to crank. Leave it in this position for about 10 seconds. If your Tahoe is equipped with the battery meter, let the meter reach its peak. Then attemp to start.
my 1999 chevy tahoe 5.7 was located in front of the oil pan, and not above the starter as so many said it would be....
it is behind the starter. You will have to remove the starter to get to it.
It should be behind the starter, Have to remove starter to see it.
It is behind the starter. You will need to remove starter to get to it. I WOULD CHECK TO SEE IF IT IS NOT IN FRONT OF THE OIL PAN 1ST, BOTTOM OF TIMING CHAIN COVER.. MY 1999 CHEVY TAHOE 5.7 IS LOCATED THERE... EVERYONE TOLD ME ALSO THAT IS WAS ABOVE THE STARTER. AND AFTER TAKING IT OUT . IT WAS NOT THERE;...
It is on the passenger side of the timing cover that is on the front of the engine.
Locate crank shaft sensor 2005 Chevy aveo
You must have been fooling with the distributor. You MUST have an engine scanner to set the timing on that engine. That will then put the cam and crank sensors back in correlation / Time with each other.
THE CRANK SENSOR ON A 97 5.7 IS LOCATED UNDER THE CRANKSHAFT PULLEY BETWEEN THE PULLEY AND THE OILPAN. SLIGHTLY TO DRIVERS SIDE
behind the starter
Turn the key to the on position (dont crank) pump the gas peddle 3 times within 5 secs lights should start blinking and then go off.
2010 chevy malibu intake position sensor