Yes you can I have 1988 Honda prelude with the 2.0L in it.
The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.
my 1988 4ws Honda prelude idles low at 600 rpm
Yes, the 1988 and 1989 Honda Prelude has a VSS that is a cable sending unit that connects to the gauge cluster in the dash.
Yes, with some custom mounts for the engine and transmission. This can be expensive if you have a shop do the work for you.
where is the fuel pump cutoff relay located in a honda 88 prelude?
if its a 2.0 then 2.0 liters of oil! 2.0 is the engine size, a 1988 Honda prelude 2.0 holds exactly 4 quarts of oil, i just changed my oil today and it says that in the owners manual.
None of the dashboard lights work on my 1988 Prelude. Why?
The fuse for the heater and the CD player in Honda Prelude 1988 can be found using?æa fuse diagram. The diagram is available online and can be found by looking for '1998 prelude fuse panel diagram' on any search engine.
Screwed into the head.
The answer is no. The fuel-injected engine from your 1987 Accord is a direct-fit into a 1985-1987 Prelude Si, but will not fit into a 1988 or newer Prelude due to a completely different engine and transmission being used. The wiring harnesses and ECU will also be very different.
under left hand head light
The 1988 Prelude Si has the optional B20A5 DOHC EFI engine. The standard B20A3 2.0 L SOHC carburated engine was not used in the Si. So you can tell by the fuel system, which engine you have. The standard engine had Carbs and the Si engine had FI. B20A3 (12-valve, SOHC, dual side-draft carburetors) Found in: 1988-1991 Honda Prelude 2.0 S HorsePower: 104 @ 5800 (MT) 105 @ 5800 (AT) Torque: 111 @ 4000 B20A5 (16-valve, DOHC, PGM-Fuel Injected) Found in: 1988-1991 Honda Prelude 2.0Si Power: 135 hp
Yes. All Preludes do.
The 88 Prelude does not use a dual timing belt. It has a single timing belt
The throttle body diagram for the 1988 Honda Prelude is found in the maintenance manual of this car. It can be obtained as a print out from an automotive store as well.
I just went through that exact problem with my 88 prelude, it was the ignition cylinder.
It should. There's very little mechanical differences when the mid-cycle refresh took place in 1990. Most of it was cosmetic, and the B21 series motor that replaced the B20 in the 1988-89 model years should still bolt on the same.
Yes it will fit, all of the twin cam third gen preludes 1988-1991 have the same motor config. You can even put the fourth gen vtec prelude motors in the third gen chassis with mount kits.
the oil filter is located on the back side of the block in the middle
Most of them just drive out. Get the new ones and you will see how they install.
If its a 4 wheelsteer model look towards centre of the car.
20 inches on the driver's side, 19 inches on the passenger side.
The ALB light comes on because of a malfunction in the Anti-Lock brake system, simply this means that you will have no ALB, but normal braking will continue.