Mini-fuse #23 15amp located side instrument panel inside of passenger door . Actual name is- Stop Lamps.
The master cylinder contains the reservoir for the brake fluid. This is where you would add it on an 1990 Cutlass Supreme.
Is that a question? They work because that's the way your terrible car was designed to work? Do you mean HOW do they work?
What fuse controls the brake lights on a 1998 Chevy Camaro? It should be labeled on the fuse block.
Fuse 7 controls the brake lights. It should be a red 10amp fuse.
One of two things. Either the brake light switch behind the brake pedal. Or try wiggling or rotating your turn signal stalk in a circle motion. If the brake lights work when the turn signal stalk is wiggled then you need to replace the turn signal stalk.
its in the steering colume replace the turn signal switch
Check the brake light switch. It's under the dash, connected to the brake pedal. If it's adjusted wrong or faulty, it could cause the brake lights to stay on. If you can use a meter and tell that the brake light switch is ok, next test the turn signal switch. Sometimes they short out and leave the brake lights on. You'll have to pull the steering wheel to do that.
There is a shifter interlock switch on the brake pedal which also controls the brake lights
what size torx for a 96 ford bronco?
It could be the brake fluid reservoir is low and is telling you that the brakes need attention.
It's on top of the brake pedal under the dash.
its the blinker control arm.if you move it back and forth you should see the two other brake lights go on as the brake is pressed.