Look for an auxiliary fuse or it may be controlled by the radio fuse.
Replace socket Replace element
Number 29 it is called +B ACC.
After you remove the center console, you can reach around the back of the dash and disconnect the power cable to the socket, then hold the "nut" on the back of the socket and unscrew the socket.
how to remove lighter socket from 2013 dodge durango console
Under the steering wheel dash area is the interior fuse box. If you have a lighter socket in the dash and one in the back of the center console, you have two separate fuses that control each one individually.
The 2006 Chevrolet Aveo OBD 2 port is under driver side dash next to center console
in my Renault scenic (2,0 16V, 2003) (not grand scenic) the obd2 socket is under the movable middle console. Move the console backwards and lift a plastic lid which appears under the console and you see the 16 hole obd2 socket. Eberhard
The 2006 Honda Civic OBD 2 port is under driver side dash next to center console
The lighter socket is found the center console of a 1999 Toyota Rav 4. To reinsert a lighter simply plug the part into the hole.
The socket is behind a small removable panel on the centre console between the heater controls and the ashtray. The panel is attached by two spring clips so can be pulled out completely by grasping the bottom edge.
2001 Toyota Sequoia: Accessing the Center Console to remove/replace the JBL amplifier powering the rear speakers. The bolts you'll have to remove have 10mm heads. Locate a crescent wrench, a long extension if you have one, and a 10mm socket. A flat blade screwdriver may be helpful in removing the wiring harness plugs, I just used my finger nails. 1. Remove the shifter knob on the center console 4WD shifter (assuming you have a 4WD model). 2. Grab the center rib of the console tray (the tray under the shifter) and lift straight up. The black tray with leather shifter boot popped up and out quickly easily without prying. 3. Next you'll need to remove four (4) 10mm black bolts to lift up the center console to get to the amplifier installed underneath. 4. Remove two bolts at the rear of the opening under the tray just removed, at the front of the center console. 5. Open the center storage and pop out the plastic CD organizer tray from the bottom of the center console storage area. 6. Remove two 10mm bolts in the bottom/rear of the section. 7. With these four bolts removed, grab the front of the center console section and lift up and back, the center console will pop apart from the front console skirt. 8. To improve access and tilt the console back higher, remove the wire bundle clip right under front of the console (probably AC controls). 9. The JBL amplifier is held down by two gold colored 10mm bolts, remove those. 10. There are two wire bundle connected to the amplifier, squeeze the tabs on the white wire bundle connectors to remove them. 11. Remove the JBL amplifier. Twenty minutes elapsed time. 12. Reverse these steps to bolt everything back up. I'll post pictures at www.tundrasolutions.com when I replace the amplifier.
7 mm. You can buy this.