Turn signals use a relay or 'flasher' which is usually located on or near the column under the dash. Brake lights get their power thru the brake light switch on or near your brake pedal under the dash; check it with a 12v circuit tester.
Brake lights and turn signals are on a separate circuit from the tail lights. Tail lights are on the same circuit with the dashboard lights. If the dashboard lights aren't working either, check the fuse. If they ARE working, check the headlight switch.
No brake lights but turn signals work? Turn signal switch brakes route through it.
my 98 suburban did the same thing. when i changed my headlight switch that turns them off and on, they started working again.
Answer Usually when the flasher blinks rapidly it's about finished. Try replacing the signal light flasher and see what happens. If you still don't have Brake Lights start looking for a short.
How do you replace brake lights
May possibly be in the multifuction switch on the left of the steering column!!!!
check the brakelight switch. it is located under the dash where the brake pedal rests. Hey its ritchie. If you can click your blinker down and then they work its you blinker switch,but this is my monte.
It depends on the vehicle but in general you would have one fuse for the signals and one fuse for the brake lights.
Brake lights
Replace brake light switch.
Fuse 7 controls the brake lights. It should be a red 10amp fuse.
Blown fuse