my 98 suburban did the same thing. when i changed my headlight switch that turns them off and on, they started working again.
Replace brake light switch.
The breake lights on a 2003 Chevy suburban come on when the car is not being uesed, becausethat is the way thay are made?
May possibly be in the multifuction switch on the left of the steering column!!!!
on the brake pedal under the dash is a brake light switch. that when you depress the brake it turns your lights on. you might wanna check that
BEHIND THE BRAKE PEDAL
The brake lights and signal lights are tied together in the signal switch, also known as the "multifunction switch".
If the brake lights do not work on Chevy Venture van 2000, try to disconnect the brake switch. Then short the two contacts of the connector to check if the brake lights are now working.
The brake light switch is bad, look on top of the brake pedal under the dash and you will see the switch, replace it and you will have brake lights.
i have tail lights but do not have brake lights nor do i have turn signals. i have replaced brake switch and all bulbs
The brake light switch may be bad or out of adjustment. The switch is located just above the brake pedal.
Your problem may be with any or all of these three items: The fuse, brake switch or bulbs in the brake lights.
check the brake light switch that is on top of your brake pedal under the dash, could be out of adjustment or bad.
Check sockets and grounds
Probably a misadjusted or defective brake light switch.
Check the fuse, check the bulbs, then check the brake light switch.
The brake light switch is broken or out of adjustment. The brake light switch is attached to the brake pedal lever above the brake pedal pad.
yes just push the emergance brake one click.
burned out bulb, blown fuse, wiring
Check the brake light switch. It should be mounted on the upper part of the brake pedal or the brake pedal frame. If the brake lights go off when you unplug it you have a stuck or shorted switch.
check the multi function switch. I hava a 96 Chevy Monte Carlo and I had the same problem . I changed the multi function switch and the brakes lights now work. the rear brake lights run thru the switch on the turn signal circuit. try it and see.
turn signal switch needs replaced!
It could be the brake light switch (the switch that activates the brake lights when you step on the brake pedal) has gone bad
If a 95 Chevy Suburban's brake lights do not work but everything else does, it may be the link that connects to the pedal that has a problem. If the pedal has been adjusted or disconnected, it may also be a reason for the issue.