Want this question answered?
For pure sanding of bondo or metal, No. If you are preping to paint or sanding primer you should use Wet or Dry sandpaper and sand wet.
The reason why metal have to be clean with sandpaper is to remove the oxide layer on the surface of the metal. This is because most metal have a high tendency toward oxygen. The metal will react with oxygen in the air and form an oxide layer on the surface of the metal.
Metal should not stain. You should be able to brush your teeth to remove everything on your braces.
quartz-based silica sand used in sandpaper, glass grinding, stone sawing (as in dimension stone manufacturing), metal polishing and metal casting cleaning, and in sandblasting to remove paint, stain, and rust.
There several ways of effectively removing a metal button on clothing. You should target the thread that attaches it to the clothing so that you can remove it with ease.
Yes, rust can be removed with sandpaper. Sandpaper can be used to scrub away the rust, revealing the underlying metal surface. However, it's important to note that sandpaper may also scratch the metal, so it's crucial to use the appropriate grit level and technique. Additionally, after removing the rust, it's advisable to apply a protective coating like paint or a rust inhibitor to prevent further rusting.
Sand the spots down to shiny metal using fine sandpaper.
No, you should remove the negative first. That way if your wrench slips and hits a metal part of the car and the battery at the same time it will not spark.No, you should remove the negative first. That way if your wrench slips and hits a metal part of the car and the battery at the same time it will not spark.
No metals do not cool off quickly.
if i was to remove metal i would use pliers
First, remove the instrument cluster bezel, the wood trimed (look) piece surrounding the speedo, A/C register, fuel gauge and temp gauge (standard). There should be 3 more Phillips head screws holding the clock in. Remove screws, unplug clock, and unscrew/remove 2 illumination lights from back. If the unit is not working, try cleaning the metal connection at the back with some fine sandpaper or steel wool. This has worked for me in my 1979. Hope this helps!
If you mean a finger nail, don't worry. It will pass on its own.If you mean a metal nail. See a doctor quickly!