answersLogoWhite

0


Best Answer

What bolt? If you mean the old drain plug , it will be self evident! Big mess on the ground and seized engine. There is no "bolt" to remove when you change your oil, only the oil drain plug.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What happens if you forget to put the bolt back on after you change your oil?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change rear oil in ford ranger?

there should be a drain bolt on the lower front or rear section and a bolt on the top remove the top bolt and put the drain bolt on the bottom back in and fill the case from the top bolt untill fluid runs out and screw top bolt back in and hit the road


How do i change oil in Oldsmobile 1993 cutlass ciera?

under the front of the car you'll see something that looks like a black tube it has a bolt on the back of it undo the bolt oil will drain out change the oil filter witch is by the belt on the motor it hard to get to but you can do it chang the filter bit the bolt back in and replace oil done


How do you change a back lawn motor tire?

Usually they are held on by one large bolt through the centre.


How do you get the bolt back in a 592M?

how do you get the bolt back in a remengton 592


Your Marlin 989 wont hold back bolt when magazine is emptyWhy?

Try a thorough cleaning, change magazines, change ammunition. The marlin 989 was made in the 60's the bolt does not open when the last shot is fired


How do you get the bolt back in a Remington 592M?

how do you get the bolt back in a remengton 592


How do you install headers on Chevy Cavalier?

un bolt the old header and bolt the new one on . dont forget the gasket


How do you change oil in 2002 Honda xr200r?

there should be a bolt near the bottom of the engine, simply remove bolt and drain oil into pan. put bolt back in and fill with motorcycle oil that meets specifications to Honda


How do you change the idler pulley on 1994 Cadillac eldorado?

Take the belt off, un-bolt the idler pulley, bolt the new pulley on, and finally put the belt back on and Viola!!


How do you change starter on a 1988 Toyota Corolla sedan?

In the back of the engine one bolt is hidden under the air box


96 suzuki esteem how do you change alternator?

Loosen bolt on arm to release tension, remove wires from back, remove arm bolt & bolt at 6 o clock, reverse to install. Use pry bar to tighten belt before tightening arm bolt.


How do you change the manual transmission fluid on a 1997 legacy and is a filter change important as well?

Usually there is a drain bolt on the bottom or side of the transmission....you can remove that bolt and let the old fluid drain out.....after it is done draining put the bolt back in and look for another bolt....possibly a little higher...i believe the legacys take 80W90 gear oil so fill it through that higher hole until it starts to leak out than put the bolt back in....manual transmission vehicles dont have trans. filters....