Not good idea, damage no, but you need to correct it. Brake and transmission fluids are both types of oils. They have different properties for wear, heat and moisture control. They have different viscosity too so you may notice issues with the brake pedal pressure required to stop.
You are in for some expensive brake system repair work. I made this mistake once a long time ago and had to replace seals-gaskets.
The transmission will fail.
No. That would be a huge mistake. Buy brake fluid. Its only $2 to $8 dollars at a store.
Accidentally pouring transmission fluid into the brake fluid reservoir is a serious mistake and can have detrimental effects on your vehicle's braking system. Transmission fluid and brake fluid serve completely different purposes and have distinct properties. Transmission fluid is designed for lubricating and cooling the transmission components, while brake fluid is crucial for the proper functioning of the braking system. Brake fluid is a hydraulic fluid that transmits force within the brake system, and it has specific properties to withstand high temperatures. If transmission fluid is added to the brake fluid reservoir: Loss of Brake Functionality: Transmission fluid is not suitable for use in the brake system, and it lacks the necessary properties for hydraulic braking. Mixing the two can compromise the integrity of the brake fluid, leading to a loss of braking functionality. Damage to Brake Components: Brake seals, hoses, and other components are not designed to handle transmission fluid. The introduction of transmission fluid can lead to damage to these components, resulting in brake system failure. Reduced Braking Performance: Transmission fluid may cause the brake fluid to become less effective, leading to reduced braking performance. This compromises the safety of the vehicle and increases the risk of accidents. If such an error occurs, it is crucial to address it immediately: Do Not Drive: Refrain from driving the vehicle as compromised brake functionality poses a significant safety risk. Professional Inspection: Seek the assistance of a qualified mechanic to inspect and flush the entire brake system. Flushing involves removing the contaminated fluid and replacing it with the correct brake fluid. Component Replacement: Depending on the severity of the contamination, brake components may need to be replaced to ensure the safety and reliability of the braking system. In summary, mixing transmission fluid with brake fluid can lead to severe consequences, and it is essential to rectify the mistake promptly by seeking professional assistance to prevent safety hazards and potential damage to the vehicle.
drain all of it out. hopefully there will be no damage to the rubber components.
The rubber seals in the brake system will be ruined in a short time rendering the brakes useless.
NO! Dont mix them and dont swap them; they are very different and will cause massive damage.
Possibly, if you are being aggressive with the excavator, setting the parking brake would take tension off the transmission though.
When you press the accelerator and brake together in a motor car, the engine will rev, but the brake will stop it from moving. Doing this repeatedly can cause the vehicle damage.
Yes, that is a very bad idea. The brake fluid will damage the trans seals, and it will start to leak.
Yes very bad news it damages the seals in the brake system causing them to swell up your looking at a very costly stupid preventable mistake.
Yes, adding brake fund to a P/S system can cause damage.