answersLogoWhite

0


Best Answer

The 3-wire is an O2 sensor with a heater thus the third wire so It either won't work at all or won't send voltage to the pcm until it is hot...

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What happens to a three wire O2 sensor if it is wired in wrong?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1987 Honda Civic fan sensor wired direct to lights battery dead why?

maybe it's wired on the wrong side of the switch


What happens IF the wires from a battery charger are put the wrong way round onto battery terminals and left to charge?

charger i had was wired wrong. soon as it was plugged in the charger stopped working. if wires are wrong it just will not charge and can be dangerous!


Why did the new light fixture fizzle out when you wired it?

You likely wired it wrong. Not sure what you mean by "fizzle out".


Sensor can be a transducer but transducer cannot be a sensor Is it right or wrong?

It is wrong.


What happens if i drive my miata with a defective downstream o2 sensor?

If driving around in a car that the o2 sensor is going bad can cause a few things to go wrong. The best thing you can do is get it fixed.


Why did your band saw motor reverse direction?

the power leads were wired wrong


I replaced the engine in my 1997 for Taurus with a 1996 now the ac won't work. Is there some wiring changes that need to be made I used the engine harness from the 1996 engine.?

i think you wired it wrong. i think you wired it wrong.


Is it wrong if the black and white wire is wired backwards?

You run a greater potential for being shocked if you connect the black and white wrong.


Why is the protection light on in my car amp?

something is wired up wrong or you overloaded the amp


Can you buy the wrong oxygen sensor?

Of course you can...


What happens if you do all badges code before you save the three legendary Pokemon?

Kony comes and abducts you for doing it wrong


Location of cam sensor on a 2000 dodge Dakota 4.7l?

Under the front of the right cylinder head. If you look up from underneath you can see the three wire connecter. ************please note that this answer is wrong...this is the location of the CRANK SHAFT SENSOR****************