The concrete would be weaker, and more prone to cracking.
The amount of steel required in concrete as reinforcement is measured using a formula that calculates the amount of pressure that will be put on the concrete. There are different formulas to identify the minimum and the maximum amount of needed steel, depending on if you are making a beam, slab, or column.
Strength and cost.
structual steel is the widw flange column's and beam's as well as plate steel angle iron ect.. it falls under aws D1.1 welding code. reinforcement steel/reinforcing steel is the rebar, dba,(deformed bar anchor), hsa, (headed stud anchor) that is placed in concrete, floors, walls, footings, ect... it falls under aws D1.4 welding code
100 TONS
A singly reinforced beam only has steel reinforcement on the tension side (along the bottom of the cross section) where as a doubly reinforced beam has steel reinforcement on both the tension and compression sides, ie. the top and bottom of the cross section.
Reinforcement
to support the concrete
The reinforcement may be in the form of "mesh" or rods. The steel reinforcing rods are colloquially called rebar(reinforcement bars).
Under reinforcement is safe because in this case steel fails before concrete.
Items used to reinforce concrete are wire mesh, rebar, and steel cables.
The amount of steel required in concrete as reinforcement is measured using a formula that calculates the amount of pressure that will be put on the concrete. There are different formulas to identify the minimum and the maximum amount of needed steel, depending on if you are making a beam, slab, or column.
Strength and cost.
It proves shear reinforcement in the beam.
A common characteristic of reinforced concrete bridges is that they feature a combination of concrete and steel reinforcement to provide added strength and durability. The steel reinforcement helps to enhance the tensile strength of the concrete, allowing the bridge to better withstand forces like tension and bending.
RCC means reinforced cement concrete....in this case the reinforcement used is steel bars.....the purpose of using the steel bars in concrete it gives tensile strength to concrete to some extent.
2%....according to Bureau of Indian Standards, Concrete design code book - IS-456
Steel is stronger than concrete. By adding some reinforcement in the compression zone of a beam, it's bending strength can be increased without increasing the size of the beam. The steel increases the compression strength, while the concrete prevents the slender steel bars from buckling.