I am person in need of a awnser " What happens when oil hits a toucch screen I am person in need of a awnser " What happens when oil hits a toucch screen
nothing happens only it gets hot that you may not want to touch at all. but thing get in the oil, the oil can start to smell and no way you want to get near that or touch because it will smell horrible?
how to reset display screen after changing oil at 15000 miles. this is on a 2008 highlander.
Usually it happens when an oil carrying boat hits a reef of in some cases an iceberg and tears or rips the hull open, when this happens the oil spills into the ocean.
An Ipod touch is made of 3 ply sheet glass. the frame is made of lightweight metal for comfort and reliability. The touch screen is activated by the heat and special oil in your hands.
If engine oil goes into the screen wash, or windshield washer fluid, the reservoir and hoses become full of greasy gunk. This will clog the hoses and reservoir. Remove and clean immediately.
The oil screen is attached to the bottom of the pickup tube of the oil pump in the oil pan.
As in oil floating in a body of water such as, say...the Gulf of Mexico, the lighting discharge would ignite the oil on the surface, and it would burn.
I don't think that it will kill you. You do not want to touch it, though because it dries out your skin terribly.
Could be oil screen on pump with sludge build up after a lot of miles if screen is clear relace oil pump if your engine does not knock mine was a dirty pump oil screen
Check inside the passenger compartment under glove box - there should be a small hole (about the size of a pencil) there may be a switch insideWith key on (engine not running) depress this switch with a pen or pencilIf so equipped that should resetHow to reset the oil change lightFor a 92, also will work for a 90 or 91, if you have the touch screen you push the INFO button and then select the oil life option and there will be a reset option on the top right of the screen. If you don't have the touch screen then press the ENG DATA button a few times till the oil life is displayed and then press and hold the reset/enter button for 5 seconds while the oil life is displayed and that will reset your change oil light.
The same as the filter in a car engine... to screen out impurities from the oil in case it damages the engine.
No filter just a oil strainer screen.