answersLogoWhite

0


Best Answer

When the 13mm battery hold down has stripped, then you have a couple of options. You could use a longer bolt of a smaller diameter to go through the stripped out section then lock down with a nut on the bottom, or the 13mm can be drilled out and tapped to a bigger size.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What if the 13 mm battery hold down bolt is stripped?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

How do you change a battery in a buick rendevous 2002?

First you have to remove the bar above the battery [It has three bolts] one behind the fuse box and two above the radiator. Then Remove negative and positive cables. The battery has a battery hold with one bolt located at bottom behind the battery. finally lift and replace battery.


Why is the asc button is flashing on your sunroof?

Battery been disconnected lately? Service work done? Sounds like the memory needs reset. Hold the open button down until it opens fully, then hold the close button down till it is fully closed. The light should now turn solid red or green depending on what mode it is in. Green is to autoshut when vehicle is shut down. Red is to override autoshut and stay open with vehicle off.


How do you replace a starter in a Pontiac Transport?

Access the starter from underneath the vehicle. Must remove the flywheel cover because the starter must drop straigt down after its two mounting bolts have been removed. Obtain re-activate codes and disarm the theft deterrant components including such things as the radio, and disconnect the negative battery cable. "SAFELY raise the vehicle", (which means the wheels must be blocked, and the vehicle, is safely supported with blocks or Jack stands in the raised position. Remove the three bolts that hold the flywheel cover on to the engine-transaxle. Disconnect the electrical connections from the starter. Loosen both the two bolts that hold the starter in place. Completely remove one bolt. Partially remove the second bolt, then support the starter.with one hand, and completely remove this bolt. This may be an ackward thing for some, but it is possible especially when you only need to begin supporting it after the bolt has been almost completely removed.


How do you remove a fan clutch on a 1997 S10 pickup 2.2L?

The fan clutch on a 1997 S10 has a bolt on the center of the front. Remove the bolt while holding the clutch still. There is a special tool to grab the clutch fan from the rear to hold it while removing the bolt.


What does clicking sound when trying to start indicate?

A weak battery. There is not enough voltage to hold the starter solonoid in.

Related questions

How do you replace battery hold down bolt on a 2001 chev. S-10?

If you don't drive it off road a battery hold down is somewhat useless


How do you replace a battery in a 1996 Buick regal?

Remove - battery cable Remove + battery cable Remove hold-down bolt on front bottom of battery tray Remove battery


How do you remove the battery when the screw that holds it breaks?

With great difficulty. The hold down is a block at the bottom that holds the lip of the battery, and there is a big long bolt that screws in to hold it down. I'm assuming that bolt broke. Start by disconnecting the battery, and you may want to remove some of the shrouds around it to give yourself some working room. Cut off the bolt as close to the hold down block as you can, ideally so it's flush with the surface of the block. Then, drill it out. Replace the bolt with a larger one, or just get a different hold down from your local auto parts store.


How do you change the battery in a 1999 Chevy Malibu V6?

first remove the cables from battery, neg, than positive, remove hold down bolt on bottom of battery. remove battery.


How do you replace the battery in a 1994 Corvette?

To remove the battery on the 94 Vette, the side panel needs to be removed.The battery will slide out the side once the hold down bolt is loosened.


Where is the hold down bracket for the battery in a 1998 ford escort?

A factory hold down for the battery is a simple plastic block of sorts at the end of a long thin bolt. There is no bracket to go across the top. The base of the correct battery has a flange at the bottom so the plastic block wedges the battery into place.


How do you remove the battery from a 2002 Chevy Malibu?

I'd like to know the same thing! Down at the side of the batt.Remove the hold down bolt and clamp.


Where can you find detailed information on how to remove and install the battery on a 1997 Chevy Cavalier?

all you need is an 8 millimeter wrench for the battery cables and a 13 millimeter socket, extension and a ratchet to remove the battery hold down. the battery hold down is at the bottom ofthe battery, and is shaped like a wedge .has a bolt through the middle of it.


How do you replace the battery on a 1993 Grand Prix?

Remove the air cleaner assembly, and the battery hold down bolt or bolts if you have two. There located on the bottom of the battery. Installation is reverse of removal instructions.


Who do you take a battery out of a 1991 Chrvy Lumina van?

First you have to disconnect the metal brace going over top of the battery,it's usually has three bolt's in the front where your headlight's are. Then you can swing the bar out enough, to get to the battery hold down bolt, and removal is pretty much easy.


How do you remove the battery from a 1999 Corvette?

Start by removing the ground cable first(negative). Then remove the positive cable. At the base of the battery is a hold down clamp, held in by one bolt. Remove this and the battery will lift right out.


How do you get the battery out of an 1984 Olds Omega?

Disconnect the negative ground cable, then the positive cable. There is a center bolt holding the cables in place. Remove the battery hold down clamp which is located in front of the battery. You will probably need an rachet with an extention to get down to the hold down clamp which is between the battery and the front of the battery bracket. It may be necessary to remove the cross piece that runs across the top of the battery in order to remove it from the car. Hope this helps.