answer
change master cylinder and slave properly then bleed the system properly.
To downshift motorcycle is squeeze the clutch and shift to the next lowest gear, release the clutch.
The 1986 Honda Prelude does not have a clutch cable. The 1986 Prelude has a hydraulic clutch instead of the clutch cable.
Does a 1998 Honda prelude have a clutch cable
It has a hydraulic clutch
Downshift. Allowing or operating the clutch to make it slip causes friction which causes heat which causes premature wear to clutch parts which causes unnecessary repair bills.
Try adjusting the clutch. Never downshift to slow down, press the clutch and use the brake to slow down it will save your engine and clutch. Downshift to pass or to rapidly speed up but be sure to have the revs up higher than when you were in the higher gear.
Yes it does
You should use the clutch anytime you shift, up or down. It is possible to downshift without the clutch, when there is little torque involved, such as slowing for a stop, but that still causes momentary high torque on the engine and transmissioin components. There is usually a torque spreader inside that will handle these torque transients, but it is designed to only handle the momentum of the transmission and final stage clutch, not the input stage clutch and engine.
You will need to remove the transmission. Remove the clutch plate retaining bolts. Remove the clutch linkage. Remove the clutch retaining bolts.
You can't aprrently on a hyrdraulic clutch, which these have that adjust automatically.
You have 2 switches A and B above clutch petal under dash
hi i got a Honda accord 95 a just put a new clutch kit in it clutch pressor plate and new beering and now when i downshift in 2nd gear it shakes a couple time tehn it stops what does that shaking ??