how to fix tajima 321 error
machine fool
A Japanese silk wholesale company
When this happened on our machine it was a loose wire on one of the start/stop switches
The CPU board is bad an needs to be repaired by a circuit board repair company. www.plrelectronics.com for example The CPU Software has corrupted, get a EX.sys disk from Tajima or find the one that came with the machine and Initialize the CPU from the Floppy Drive built into the machine. Very Rarely the CPU is actually faulty, unless you are very rich ... $3000 rich. Regards, Masis.com
The price for a Tajima embroidery machine will vary depending on the size of the machine. Smaller embroidery machines can be purchased around $400 where as larger machines can cost up to $2800.
Check with http://www.PLRElectronics.com or http://www.madpunch.com It means that your X or Y driver (boards) are bad....
What dose error code d1.14 mean on tajima
I depends. It's either a sensor, it's wiring, or potentially the control card. Or it may be caused by wrongly positioned mechanisms of the main shaft.
The cast of Tajima - 2011 includes: Nobuhiro Tajima
You can get the instruction manual from Stitch It Intl (link below).
The manual said to check the belt and sure enough it was broken in half. Unscrew the panel on the left hand side of the machine, where you put the allen wrench in to manually turn the needles up and down. The belt is right there. $110.00 to replace.