Put in the key, turn key to ACC position, step on the brake and keep on the brake until this whole think is done, put trans into Neutral. Turn the key ON - ACC - ON - ACC - ON - ACC - ON and then wait a few seconds the codes will show up on the odometer display
firstly is it your vehicle? yes it is my car Turn key to acc 3 times...horn will beep...leave key on acc...
Sounds like a short.
you have to engage the e brake and the key must be in the on position, not on acc.
It will not hurt anything to leave the key stuck in the ignition on ACC in a Mazda van for short periods of time. The ACC slot on the ignition allows the driver to use accessories such as the air conditioner and radio without the car being in motion. If the key is left in this position for too long it can run down the battery in the car.
Turn the key to acc. and push the plunger in located on the Ignition lock housing
you have to engage the e brake and the key must be in the on position, not on acc.
It stands for Accessories. It's about like turning the key to the left on an American car.
No it doesn't. The acc wire on your stereo is for accessory from your ignition switch. That's so you can turn your car key back and run your stereo without turning on the engine.
I Believe Its Turn Ur Key To Acc Then Set Ur Odometer To Mileage. Turn Off Key Then While Holding Odometer Switch Turn Back To Acc . Itll Blink Then Reset. That's How U Do It On An 05.
You need to replace the egnition key cylinder.
Turn the key to acc to allow the radio to come on, wait for it to display CODE, and then enter your 4 didgit radio code. If you make a mistake, turn the key off and on, and try again. If you make 5 mistakes, turn the key on to acc, wait 1 hour, and it will reset.