Auto Parts and Repairs
Timing and Firing Orders
Ford Ranger XL
Ford Ranger XLT

What is Ignition timing procedure for a 1992 Chevy s10 2.8L v6?

Top Answer
User Avatar
Wiki User
Answered 2007-12-24 17:36:32

I know that you have to put the truck in base timing mode for my 93' but I have a EST or HEI style ignition. If you have the electronic distributor then find the grey wire with a plug on the end of it next to the A/C box on the left side under the hood near the firewall. It will be hanging out of the wire harness. Apply 12 volts to it from your battery with a jumper wire and the truck will go into base timing mode. then line up the marks on your balancer. take the jumper wire out and your set.

User Avatar

Your Answer

Still Have Questions?

Related Questions

What is the ignition timing spec for a 1992 Chevy Camaro with 305?


Where is camshaft pulley ignition timing location for 1992 Toyota Corolla?

where is camshalf pulley ignition timing location for 1992 Toyota corolla?

How much time on average is to replace the timing chain on a 1992 Chevy Corsica?

It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.

What is the ignition timing spec for a 1992 Chevy K1500 pickup with 4.3 liter engine?

advance your timing 6 degrees due to this ethanol crap fuel we run now

How Do You Replace Ignition In 1992 Cavalier?

how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder

Does a 1992 Chevy truck have a timing chain or belt?

it has a timing chain NEUTZ

Where are the timing marks located on 1992 Saturn?

No need for timing marks on the outside of the engine that has no adjustable ignition timing.(DIS)

How do you change the ignition switch on a 1992 g20 Chevy van?

Begin by removing the retaining ring at the top of your 1992 Chevy ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.

Where is the Ignition Module located in a 1992 Chevy Corsica?

The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

How much does it cost to replace the timing belt on a 1992 Chevy Lumina?

$ 5,000

How do you set the timing on a 1992 b2200?

The full procedure is a bit lengthy to write out so I've attached some links below to show you how. To adjust your ignition timing loosen the 12mm bolt in the middle of the distributor slide and move the distributor towards the front of the truck to advance the timing, move it towards the back of the truck to retard the timing.

What is the ignition timing spec for a 1992 Chevy K1500 Blazer with 5.7 liter engine?

I have a 1994 5.7 k1500, and my book says for V8 5.7 1988-1995 is TDC. (top dead center)

How do you set the timing on a 1992 Chevy 1500 2wd 305?

Computer controlled and not adjustable

What are signs and symptoms of a bad ignition coil on 1992 Chevy astro?

No electrial spark or fire at the plugs.

How can i remove the key which broke off in the ignition in a 1992 Chevy Lumina Z34?

Gum maybe?? or tweaser??

How do you adjust timing on a 1988 Chevy Camaro?

Adjusting the Timing On Fuel Injected 1982 - 1992 F-Bodies Things you will need: You MUST definitely use a timing light to adjust your timing correctly.

Where is the timing connector wire to set the ignition timing on a 1992 Chevy 350 truck?

it is behind the black cover on the fire wall passenger side top it is a one wire connector protruding throught the wiring harness and taped to it. it has one wire tan with black tracer. hope this helps

What is the correct Timing Marker position for a 1992 Chevy Lumina 3.1L V6?

number1 piston up timing marks align with each other

What is the timing for a 1992 Chevy 1500 truck with 5.7L V8 with automatic transmission?

Timing sets at 0 / ZERO TDC. (Top Dead Center )

1992 Chevy Camaro RS 3.1L fuel injectors not working?

it is probably a bad ignition module or computer

Does a 1992 Chevy lumina have a timing belt or a timing chain?

2.5-chain 3.1-chain 3.4-Both chain and belt (ain't that be-you-tee-fal?)

Why wont a 1992 dodge spirit start after changing head gaskets and plugs?

incorrect ignition timing, no fuel pressure, or no spark.

1992 bronco will not start did every test known help?

Does it turn over? Does it have fuel, spark, compression? Is ignition timing correct?

How do you set timing belt for 1992 Chevy Lumia 3.1?

Get the Haynes manual for the unit, they have a good, detailed diagram on aligning the timing marks on the timing gears being turned by a chain. There is no belt on this engine.

What is the ignition timing degrees for a 1992 Chevrolet c1500 4.3 liter because the underhood emissions label is gone?

0 degrees BTDC.

Still have questions?