0
What is The appropriate EST for performing a resistance test on a potentiometer-type TPS isolated from its circuit?
Wiki User
∙ 11y ago
DMM
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is resistance between primary and secondary winding of transformer?
The primary and secondary windings of a mutual transformer are electrically isolated, and should have 'infinite' resistance between them when measured appropriately (which depends on voltage ratings of the windings).
Does the ohmmeter need to be parallel to the load when measuring resistance?
It does not matter, since the ohmmeter needs to be connected to the device in isolated mode. Series or parallel; they are both the same, in this case.
What does ohm means?
If you got a resistor then the resistance R of that thing can be measured in ohms. Use an ohm meter. If you got a battery then the voltage V of that thing can be measured in volts. USe an volt meter. ---------------------------------------------------------------------------------------------------- This was George Ohm's idea way back in 1827. Basically he found out that if you measure the potential(voltage) acrossed a conductor(non-changing) that the resulting value(in ohms) is proportional to it potential. Or in other words, V=IR. Since this equation has no exponents or coefficiants the isolated variable is always in proportiion to the other two. The word "ohm" means a measure of resistance or a measure of the difference is V/I.
Which resistor network has polarity bussed or Isolated?
bussed
Why gate circuits are isolated from the main circuit?
Gate circuits should be isolated from the main power circuit to avoid any damage to the power circuit if gate is damaged.
Which muscles are isolated when performing the leg curl exercise?
soleus
When an equation contains addition can the variable be isolated by performing the opposite process namely subtraction?
Yes.
What does a megohmeter or megger test?
It checks resistance from a circuit or an electrical component to earth, to make sure it is electrically isolated. This must be a very high value of resistance, hence 'megohms'.
Why was it difficult for Jews to organize resistance against the nazi holocaust?
It was hard to communicate, people were isolated and travel was restricted.
What is one thing to be aware of when performing debris removal?
wires may still be energized, delay until electrical system is isolated
Does providencia bacteria ferment lactose?
No, it doesn't. After performing the Lactose fermentation test, the isolated colonies will turn yellow meaning that the test was negative.
What behaviors could damage the ureters?
If the ureters are not properly identified and isolated during surgical procedures, such as performing a hysterectomy, they can be inadvertently cut and damaged.
What is resistance between primary and secondary winding of transformer?
The primary and secondary windings of a mutual transformer are electrically isolated, and should have 'infinite' resistance between them when measured appropriately (which depends on voltage ratings of the windings).
How do you check if a diode is serviceable?
use a vomm set to infinite resistance if you have reistance one way and not the other way. diode is good (must be isolated from circuit) if no resistance both directions diode D.O.A.
On a 77 GMC 350 HEI system with a new pickup coil why can you get no reading for resistance between either wire and ground What could cause this you can get resistance readings everywhere else?
The resistance to ground should be infinite, becouse its an isolated circuit. Any resistance to ground less than infinity would mean there is a short to ground.
Is the urine colony count an appropriate indicator of the need for an antimicrobial susceptibility test of an organism isolated from urine cultures why?
water than more wayer
Does the ohmmeter need to be parallel to the load when measuring resistance?
It does not matter, since the ohmmeter needs to be connected to the device in isolated mode. Series or parallel; they are both the same, in this case.
