its on the front of engine it holds the cam sprocket from spinning so if you pull off the sprocket you will see it hope this helps
a dowel is often refered to as a dowel pin so it sounds easy but it might be a pin
It is located on the inside of the distributor . Three pin connector .
Bowling pins? Sewing pins? Dowel pins? Jewelry pins?
The 1995 & later Optispark distributor has about a 2" diameter wheel with three circular depressions and three rectangular depressions. On closer inspection, you'll note the only one of the three rectangular depressions is a true rectangle. The other two are more of an hour glass shape. The dowel pin on the camshaft's end must be inserted into the depression that is a true rectangular shape. Leave the cap off the distributor before engaging the pin in the slot and you'll be able to turn the rotor on the distributor and make aligning them MUCH easier! If you get them properly engaged, the mounting tabs of the distributor should sit nicely on the mounting bosses of the timing cover. If the tabs and bosses don't touch, the pin isn't properly inserted into the correct slot on the distributor.
the camshafts are identical,take the bolt out of the camshaft sprocket and you will see how the camshaft pin is positioned, that is what makes a intake camshaft or a exhaust camshaft
The camshaft is in the cylinder head.
If this is a wooden dowel pin, coat it lightly with yellow glue and insert one end into one part to be joined, tap in lightly about half way. Now line up other piece and put together with a clamp that fits over all . If no clamp is available, place one end against a work bench and tap the pin in with a carpenter or claw hammer.
Where is a camshaft position senser located on a 2006 Dodge durango/
The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.
The Camshaft sensor is located in the distributor.
The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.
On a 1999-2005 model Mazda Miata the camshaft position sensor is located on the valve cover towards the rear of the engine (closest to the firewall). It has one 3-pin connector connected to it and one 10mm bolt to remove the sensor