0
Need to know the year, make and engine size of your vehicle.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Are your valve seals bad if oil is getting on your spark plugs and its not smoking?
if you were getting oil on your plugs it would smoke something cronic,try looking more into your ignition system if its starting problems if it has a distributor have a look at your points under the cap, if it is Electonic ignition have a look at your crank angle sensor or cam angle sensor.
Why won't the truck turn over after replacing with a new crank sensor?
your crank sensor has absolutly nothing to do with the ability of the engine turning over. I would look at the wiring to the starter.
Where is the crank angle sensor on a 1993 dodge Dakota 3.9?
Top passenger side of the bell housing. Look behind the passenger side cylinder head.
95-96 eagle talon esi ran fine changed the flywheel out and now you have no injector pulse and the car wont start what do you look for and how do you fix it?
crank sensor also check cam angle sensor
What does a Honda city crank shaft sensor look like?
crank shaft sensor or(ckp) is look like a simple sensor.its color is black.its lenth is two inches.GILL G
If your crank sensor goes out how do you know which one to change?
There is only one crank sensor fitted, you may also have a cam sensor. the crank sensor is located either around the bellhousing or around the front crank pulley. It either has 2 or 3 wires. It picks the signal off the revolving crank so look for a sensor in the block near flywheel.
How do the crank angle sensors position on a 1993 Mazda RX-7 turbo?
there is no crankshaft in an rx-7, it has a rotary engine C12 - actually there is, its called a crank angle sensor but it is located on the block and measures the eccentril shaft (which is the equivilant to a crankshaft). if you look at the biggest metal pulley at the bottom of the engine the crank angle sensors are on the side of the strange looking metal plate on this pully, two short stuby looking things.
Where is the crank position sensor located on a 1993 Infinity G20?
trying to replace crank position sensor but i have no ideal where to look it is 1993 infinity G20 could you help me find this sensor
Where is the crank position sensor located on a 2003 savanna?
behind the starter look for three wire sensor
How do you change the crank shaft position sensor in a 2003 Hyundai Santa Fe?
Start by pulling the cover on the bottom of vehicle. remove cover on starter and if you look at an angle towards the driver side up and in you will see the crank sensor. 10mm open end wrench will remove the bolt. trace plug to top driver side.
What would cause an 87 Buick Park Ave to stall and not start act like no fuel when warm?
Could be cam sensor, crank sensor, throttle position sensor, mass airflow sensor or the magnet on the crank. We just replaced all of the above and found out the hard way it was the last...and cheapest. Pull the cam sensor, look at the end of your cam and see if the magnet is damaged.
Will a 1995 Chevy 4.3 vortec engine work in a 1999 Chevy blazer?
From what I've experienced, up to 1995, they don't have a crank sensor and 1996 and later has one. It would reason that it would be a lot of work to get a crank fitted or cut and then install a timing chain cover to accept the crank sensor. Other than this. I would think it would work. Maybe look for a kit that would do this for you. Good luck. yes but would be different wiring
