0
What is a good site for buying distributor caps plugs and rotors for outboard motors?
Tobiasdaven
Advance Auto Parts, Auto Zone, O'Reilly's, Pep Boys, or most other Auto Parts stores.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you you install a distributor on a 1998 astro van?
how to install distrutor cap and rotors in a 1998 chevy astror van
What is the hermetic motor?
Hermetic motors are motors used in hermetic compressors. Hermetic motor use wound stators and squirrel cage rotors, without shaft bearings and have a relatively tight design.
Replace a Chevy 350 distributor rotor?
There are a few different styles that were used over the years, but if you go to the auto parts and buy a new one for your application you will be able to see how it's held on. It's under the distributor cap. It's generally accepted policy to replace the rotor and distributor cap at the same time. Just make sure you connect the wires to the same place on the new distributor and don't "FORCE" anything. Distributor caps and rotors are made of a strong but brittle plastic and will break. Many of the rotors are just "pressed" onto the shaft with your fingers but some are screwed to the centrifugal advance mechanism. It depends on your distributor.
How is a motor used in the generation of electricity?
Motors turn rotors that rotate coils of wires over a magnetic field, which creates an electric current in the wire.
Can I rotate the front and rear rotors on my 08 Impala to avoid buying new ones so often?
No, they are different part numbers.
Where are car roters located?
If you are talking about the brake rotors that is what the brake pad make contact with to stop the car. If you are talking about the ignition rotor it is located inside the distributor cap.
Should you put dielectric grease on new cap and rotors?
Noway! It's a bad idea and isn't necessary. It is okay to put it on the distributor cap button though.
What has the author D H Hibner written?
D. H. Hibner has written: 'Experimental study of transient dynamics of a flexible rotor' -- subject(s): Vibration, Rotors, Motors, Airplanes
Is it a law that brake rotors must be replaced by law if needed?
Yes. You should also get a second opinion from another mechanic before buying the job.
What causes a grinding noise after you got new brake pads and rotors?
This is often caused by installing new pads on worn or slightly worn rotors. Buying new rotors or turning the same rotors would make a smooth surface for the new pads to rub against. Any surface that is less than smooth will cause some grinding for a few days or maybe longer. It also shortens the life of your new pads.
Starting poblems with cap and rotors?
does the engine turn over at all? your distributor may not be the problem. do the lights work with the car turned off? If not or if they're dim, you need a new battery.
What rhymes with motors?
voter odorboater, floater,borderThere are several words that rhyme with moter. I am assuming that it is pronounced like "motor."boaterdoterfloatermotorquoterrotorvoter
