0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How hot will a 40 gallon hot water tank get?
As high as the highest setting available on the tank.
What is a Pachuca tank?
A Pachuca tank is a high narrow tank with a central cylinder for the introduction of compressed air, used in the agitation and setting of pulp during treatment by the cyanide process.
What was the setting of nemo video?
The Ocean. Supposedly near Australia, because the scenes in the fish tank take place in a fish tank in Australia.
How many shots does a 10oz c02 tank last for?
Depending on the setting of the gun close to 200 shots. I have a 9 oz co2 tank and it usually goes for about 150 to 175.
In setting up a water tank why we must put it higher than our house?
Water flows down from a height. If the water tank was not higher than your house, the water from the tank would not flow to your house without the use of a pump.
How do you reset the gas pump setting on a 1992 ford ranger?
Fill it up. If it stays on with a full tank, then the sensor is bad.
Why are your fish moving stones after 3 years in a bigger tank?
they might be territorial fishes so they might be setting up their territory
How Can you Multibox Druid tank and Enhance Shammy?
Yes you can. It is just a matter of knowing how to multi-box and setting the keybindings to the correct spells.
What chemicals work best for setting up a hospital tank?
This will fully depend on what illness you are treating, or if you are setting up a quarantine tank to house new fish before adding them to your main tank.The 3 important items are a filter, a heater, and aquarium salt (or epsom salt). Other items would be melafix, pimafix, and/or prazi.
How long will a 100 lb propane tank last with only using for gas log fireplace?
Depends on usage of fireplace. Have propane tank topped off monthly to figure out how much gas being used. Either that, or wait until tank is empty.
How do you change a fuel pump on a 96 Chevy K1500?
easy way is to take the bed off and drop the gas tank fuel pump is setting on top.
How do you measure the pounds per square inch that a tank is exerting on a floor?
You take the weight of the tank and divide it by the number of square inches that touch the floor. If you have a 400 pound tank sitting on a stand with four legs of 1 square inch each, the tank would be exerting 100 pounds per square inch. If the same tank is setting on the floor and has a footprint of 10 inches by 20 inches, it would be 2 pounds per square inch.
