It is best to remove the torque converter to change a gear box on a Nissan. This will help there to be a smoother time adjusting the gear box.
115 ft
Preferably in a box or tray where it will not get damaged.
Torque wrenches can be purchased at any hardware store like Home Hardware or Canadian Tire. Torque wrenches can also be found at big box stores that sell tools like Sears.
The rocker box bolt torque specifications, on your Harley-Davidson, is 15 pounds per square inch. The bolts should be torqued in five pound intervals.
The rocker box bolt torque specifications, on your Harley-Davidson, is 15 pounds per square inch. The bolts should be torqued in five pound intervals.
it has to do with gravity, weight, friction, torque, and force..... simply put your lateral force (pushing from the side) has to exceed the friction caused by the box and the surface its on
Rocker assembly 135ftlbs rocker box or housing is 35ftlbs
For all the 2.3, 2.4L QUAD 4 engines, the head bolts are Torque to Yield. The porper torque value is 30ftlbs PLUS a 90 degree turn of the wrench. The bolts must be new every time ( NEVER REUSE OLD BOLTS). The torque values and proper sequence are including in the box the new bolts come with. BUT honestly, the torque value is 65ft lbs like all GM Chevy motors have been for eons.
rotor contactor are used to cut the resistance in slip-ring motor connected through resistance box. resistance is proportional to torque. so by controlling rotor contactor resistance can be controlled and hence torque can be controlled. for more information check torque and speed characteristic of wound motor.
Electromagnetic torque and load torque are different.Electromagnetic torque is the torque that is produced inside the machine which makes the machine rotate,while load torque is the torque that is applied externally with brake drum and and spring balance.Electromagnetic torque can be varied by varying the speed of the machine,but load torque is fixed.
An intermediate shaft is a part of a car. It connects the end of the steering column to the rack and pinion gear box and is used to eliminate torque sheer.