Alkyd Enamel is really old school primer. I personally would sand it with 400 wet/dry and put a coat or two of an epoxy primer over it then you can put just about any type of paint on it. If you don't want to do that, probably your best best would be n Enamel top coat , You can still get Automotive Enamels but they will be expensive because the EPA is really cracking down on the solvent based finishes. Color selection may also be limited but they are out there. And even if you use an enamel , you should clear coat it with a Urethane Clear. IT helps protect the base coat from fading and gives a great gloss when buffed. I have painted a lot of cars with Enamels and they go on fairly heavy so watch out.
You can use either a water based alkyd primer, or a 100% acrylic primer under a water-based alkyd paint.
Alkyd is a resinous binder used in paints to bind other components and make smoother paint.
You can use either a water or oil-based paint over a latex primer.
Almost any kind, including epoxy enamel.
you must first sand it so to remove any shiney surface then put a primer like bullseye then an all surface paint usually an alkyd or oil based
You can use any kind of enamel paint, but I would recommend an oil based paint, remove all oil, dirt, grease, dust and simply paint. (spray painting will give you a better finish)
use a semi gloss or high gloss enamel as the hold up to scrubbing very well
You can use either a water or oil-based paint over a latex primer.
Almost any kind, including epoxy enamel.
you must first sand it so to remove any shiney surface then put a primer like bullseye then an all surface paint usually an alkyd or oil based
You can use any kind of enamel paint, but I would recommend an oil based paint, remove all oil, dirt, grease, dust and simply paint. (spray painting will give you a better finish)
use a semi gloss or high gloss enamel as the hold up to scrubbing very well
Most likely auto enamel paint.
Use oil based enamel paint.
A primers is basically used to seal a surface and give the top coat "tooth". A primer should be chosen for the surface it is going on, oil based primers adhere better to surfaces like bare wood, slick finishes, and old oil based paint. Once the primer has dried any kind or paint may be applied as a top coat.
It's primer made with a latex or acrylic base. You can use any kind of paint over this.
Sterling Silver is a metal, therefore you can apply paint. Silver Jewerly is usually polished, and you must give the paint some tooth to grab hold of, (rough the area with fine sandpaper, 400 or 500 grit) also consider a metal primer, depending on the kind of paint you use. (I recommend a quality enamel paint)
that is fine as long as paint is dry before coating
Enamel or Melamine .