The code in which you are referring to is from the OBD-O B16A Pr 3 ecu. Code 22 which is the Variable Valve Timing & Valve Lift Electronic Control Pressure Switch... aka (VTEC Pressure Switch) Hope this helped.
no. must be the same. you may be able to get away with OBD0 (zero)
Engine check urgently
The check engine light comes on when the ECU detects a problem with the emissions system on the vehicle. Have the ECU scanned to retrieve the code that has been set. The code will tell you where to start looking.
the symbol of the engine with the lightening in the middle means your ecu has gone it "safe mode", also known as "limp home mode" , this means your ecu has detected a fault on your ecu/engine/braking systems. A mechanic with a fualt code reader will be needed to get your ecu to tell him whats at fault
yes it will, i had the same issue with my car. but the answer is yes
Get the ecu codes read, there is a fault code listed in the engine ecu
no you cannot it is incorporated inside the engine ecu it works by receiving the code then allows the ecu to supply the voltages to the correct components
The check engine light comes on when the ECU detects a problem with the emission system in the vehicle. Have the ECU scanned to retrieve the code that will tell you what part of the system is being effected.
The Check Engine light is alerting you to the fact that there is a problem somewhere with the emissions system on the vehicle. There is a code stored in the ECU that will tell you what part is being effected. Have the ECU scanned with an OBD2 scanner to retrieve the code,
for ecu reset must disconnect cable battery for 45min and reconnect battery cable and start the engine
The Check Engine Light comes on when the ECU has detected a problem with the emissions system. Have the ECU scanned with an OBD2 scanner to retrieve the code that has been set. That code will tell you where to start looking for the problem.
The Check Engine light comes on when the ECU detects a problem with the engine emissions system. Have the ECU scanned to retrieve the code that has been set. This code will tell you what part is being effected but not necessarily the defective part.