Want this question answered?
A. A 2-in schedule 40 sheets pipe is used as a leg for a machine. The Load carried by the leg is 2350lb. a. Compute the bearing stress on the floor if the pipe is left open at its end b. Compute the bearing stress on the floor if a flat plate is welded to the bottom of the pipe having a diameter of the pipe
it is defined is the stress in the material(steel,Al,etc) that will not be exceeded under normal operating condition
The the bearing capacity of silt soil can be improved by:Compacting the soil to increase it's density.Increasing the depth of the foundation layer as the increased effective stress will act to increase bearing capacityThe use of geosynthetics may act to increase bearing capacityThe use of lime stabilisation / soil mixing techniques may also act to increase the bearing capacity of silt.
Fracture point
When we mix additives in the oil/fluid, the forces which are present in the fluid opposes the forces of additives. This opposition makes a couple force and hence a couple stress is induced in the fluid. This type of fluid is known as couple stress fluid.
primary stress bearing areas are the areas to which the forces acting are pendicular
According to Anthony LP primary stress bearing areas of mandibular denture is the alveolar ridges and secondary stress bearing area is the superior part of mylohyoid ridge. however as Hayakawa noted in poor cases whereas ridges are flat, the sole area of resistance to occlusal forces is the buccal shelf area.
"Load bearing" is a term used to describe any structure or support system designed to bear a load of some sort. "High load bearing," by definition, implies that the item will hold heavier weights and higher levels of stress.
In geotechnical engineering, bearing capacity is the maximum vertical stress that the ground surface (or any other subsurface strata that the vertical stress may act upon) can support without significant settlement or foundation failure.
Sear stress are forces applied in opposition, producing a shearing or tearing force. Bearing stress is a load placed in one direction, such as the weight of a building bearing on the foundation.
The lower lumbar vertebrae are the most stress bearing vertebrae.
"Underground" is a compound word with secondary stress on the second syllable ("ground").
Primary Means, it is individual there is no dependence, But Secondary will allays depends.
Tensile Stress is approximately two times the shear stress.Relationship bet n Tensile Stress and bearing stress varies from application to application.It Depends on Various Factors.
Secondary stress is the stress caused by the secondary things. It always affects you from the back of the mind. It causes that person very low.
The definition of stress management is to control stress. Good stress management provides a healthy way to relieve stress.
Secondary stress refers to the second syllable in a word that has less emphasis than the first. The second syllable must have an accent mark in order to be considered a secondary stress.