answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2011-04-28 20:54:22

3.8 liter ( 232 cubic inch ) V6 on the LS and a 5.0V-8(302) and 5.0H.O(mostly special order/option).. Some say there was a 5.7L also, but I.m not sure(?).

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


cougar 1989 no lighting in dash instruments or speedometer. Where do I look for an open circuit. Fuses all checked good.


The Cougar Song died on 1989-12-21.


They are the same size, but the largest wolves are a little smaller than the largest cougar.


Well if you look at the 240sx you will see that although the engine size is the same KA24E the engine on the 240sx is SIDEWAYS.


That depends on the size of the engine


A 1989 Ford Bronco II has a ( 2.9 liter / 177 cubic inch V6 engine )


Technically, yes. But, it would require quite a bit of fabrication and modification on your part. It would depend on the engine, since every engine is different in size.


Nedd the following information; Year model: Engine size: V8/V6:


The Mercury Cougar is not a Sports Car. It is a muscle car if it has the high performance engine.


P205/70R15 comes standard on the LS model for that year. P225/60VR16 is standard on the XR7.


A Lion is stronger than a cougar, A lion is at least 11/2 times the size of a Cougar


Yeah, you should be able to. I had an '84 with a 3.8 L V-6.


2.0 liter ( 121 cubic inch ) DOHC - 4 cylinder engine


my tire sizes for my cougar are P215/50R16 or go here so you can find your size http://www.dragtimes.com/Mercury-Cougar-Tires-m31-n237.html


how can you start a '89 mercury cougar with a broken ignition switch?


No , not according to the Gates website ( they make timing belts etcetera ) The 2.0 liter four cylinder engine in a 1999 Mercury Cougar is NOT AN INTERFERENCE ENGINE


That depends on the make, model, and engine size of the vehicle.


According to the Gates website ( they make timing belts etcetera ) for the 2.0 litre four cylinder engine in a 1999 Mercury Cougar : ( No , it is NOT an interference engine )


the 99 mercury cougar inline 2.0L engine has 125 hp and 131 lbs/feet of torque the v6 cougar 2.5L engine has 170hp and ? lbs/feet of torque


That is a 1989 Ford Mustang : ( With the High Output version of the 302 cubic inch / 5.0 liter V8 engine )


On a 1997 Mercury Cougar : The engine oil dipstick is on the drivers side of the engine ( for the 3.8 liter V6 and the 4.6 liter V8 )


It dependsprimarily on the engine in the Explorer, and the engine in the Cougar, and the years of each. If the Cougar is 1989-1997, equipped with a V8 (which would mean the tranny is an AOD - specifically, 4R70W) and the Explorer is a 5.0 between 1994 and 2001, it'll have the same transmission. Of course, if you're taking a transmission out of the Cougar and in to the Explorer, the gearset won't be heavy enough, and you'll just end-up ruining it. In the other direction, you might notice a loss of performance because of the gearing. But, it's pheasible if your options are limited.


On a 1995 Mercury Cougar : The automatic transmission fluid level dipstick is in the engine compartment , near the firewall , towards the passenger side of the engine ( at the rear of the engine where the transmission is bolted to the engine )


A little more information please ( model year , engine size ) ( my friends 1967 Mercury Cougar GT with the 390 cubic inch V8 does not have any catalytic converters ) The animal wouldn't have any either.




Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.