There are a lot of Sears Ranger rifles - what is the Ranger model number?
Loosen the screw on the forearm push up on the screw and the barrel will pull out
If your Ranger is a bolt action 22, it is likely a Marlin Model 81 made for Sears, and wearing their brand name. Step 1- open the bolt, and check that there is NO ammunition in the rifle. Do that twice. Then open the bolt, depress and hold trigger, and slide bolt out of the rifle. Step 2- Remove the large screw on the underside of the stock. You can now lift the action from the stock. The inner magazine tube can be turned, and withdrawn from the outer magazine tube. STOP. Do not disassemble the rifle further.
gunpartscorp website.
Numrich gun parts corp.(E-gun parts.com).
There is a screw underneath the barrel on the end of the frame, take out the screw, take out the mag, and open the bolt. Then just pull the frame off of the gun.
. to remove the bolt on this model you must lower the tube assembly,there is a screw under the stock, remove stock first.
Your rifle was made by Savage for Coast to Coast Hardware, and is a Savage Model 87J. The screw is available from Numrich Gun Parts Corp (look up their website). It is part # 105500A, and sells for $2.35 plus shipping. They are in stock at this time. Good luck- shoot safe and shoot often.
If It is the factory res, then it should be screw off.
no
The one screw basically.
If you are talking about the line it compresses in.
A model E converter does not have an idle screw. Your idle adjustment would be on your Mixer, equivalent of the carburetor.