answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What is needed to replace the original ignition system in a 84 Dodge D-100.3.7 slant six?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What part is needed when the steering wheel locks?

Usually you have replace the ignition key cylinder.


Where is the Location of ignition coil 2004 suzuki Verona?

They told me that i needed to replace the ignition coil on my 2004 Suzuki Verona, my question is how do i know which to change because i just found out the are 6 of them. Do i have to replace them all?


What is Junkers gas boiler error code F0?

F0: internal error. Check the contacts and the position of the ignition cables/head. If needed, replace the PCB panel.


How do you fix multi cylinder misfire on a 1998 Chevy cavalier?

start with cleaning the fuel injectors then replacing spark plugs Plug wires Checking Coil Pack towers for cracks/damage replace if needed Check Fuel Injection/Ignition/ECM wiring for damage Check Engine/ECM Grounds Replace Ignition module Check Engine Compression/excessive piston ring/valve wear Replace ECM/PCM


What Parts are needed for tuning up a 1989 Lincoln 5.0 engine?

Spark plugs, distributor cap, and distributor rotor should be replaced. Ignition coil should be checked for corrosion at the post. Clean or replace as needed. Spark plug wires should be inspected for corrosion. Clean or replace as needed. PCV valve should be cleaned. Fuel filter should be relaced. Air filter should be inspected and replaced if needed. Oil and filter should be changed if applicable.


What is the factors needed for combustion to happen?

Fuel. Oxidizer. Ignition source?


92 Oldsmobile cutlas ciera s you can put the key in and take it out it beeps like its working but it wont turn either direction and prior to the key came out while the car was on?

Sounds like a new ignition switch is needed Sounds like a new ignition switch is needed Sounds like a new ignition switch is needed


What are the three vital components needed for a fire to start?

oxygen, fuel, ignition


Is it possible to bypass the ignition coil temporarily in a 1993 Mazda b2600?

Ignition coils generate the voltage needed to create the spark for ignition of the fuel air mixture, without it the vehicle will not run.


What would make a 1990 Chevy 350's valves act up when going uphill?

Theres a # of things that could cause that problem : Ignition timing high,---Check and adjust. Engine overheating or running hot. Check. Knock Senser bad, Check and replace if needed. Electronic Spark Control Module shorted are open circuit. Check and replace if needed. BAD FUEL ,


Why can you light up a candle with a fart?

3 things are needed for combustion... air, fuel, and a source of ignition. seems you're lacking a source of ignition.


Tools Needed to replace front brakes 2002 Ford Focus?

Tools needed to replace front brakes 2002 Ford Focus?