0
6:oo position on cap
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you install distributor on a 1995 Jeep Grand Cherokee?
Try putting the number one piston on the top of the stroke.
Which number follows 258?
There is no such number. Given any number bigger than 258, it is always possible to find a number that is nearer to 258 and bigger than it. So that number would have a better claim to be next. But then it is possible to find another number that is nearer to 258 and bigger than that one and so the newest number has a better claim. And so on.
Is is possible to swap a 242 L6 4.0L Jeep engine into a 1987 AMC Eagle with a 258 L6 4.2L engine?
With some modification it could be done The blocks are nearly the same. If you use the 258 intake and distributor in the 4.0; the only part that will need modifying is the exhaust from the manifold. I did one in a weekend using a 727 from a 91 wagoneer and a 02 4.0 engine. I used the 258 intake, carb, and distributor. I used the old v belt system to make it easy. It's easier to mod up an engine that's already running than making it work later.
Can't find the distributor cap on Jeep Liberty?
Doesn't have one. It is a coil on plug system.
Which wire is number 1 on vortec 4.3 distributor cap?
where is number one on a vortex 4.3 v-6 distributor cap
What is the number one software distributor in the United States in 2009?
Integra Telecom was the number one software distributor in the United States in 2009. Integra telecom was honored my Mitel on July 22, 2009. The number one software distributor may have changed over the years.
What is number one on distributor cap?
I cannot answer this question.
Why does only the number one spark plug wire have spark on a 1993 jeep Cherokee?
There is a break in the electric power trail to the plugs. More than likely there is corrosion on the distributor cap where the points of metal connect.
How can you tell where the number 1 wire is on a distributor cap?
number one wire will point to the number one cylinder
When timing a 350 engine does the distributor point to the number one piston or the number one spark plug?
Yes the rotor should be pointing to the #1 cylinder when you are installing the distributor.
How do you install a distributor on 2000 blazer?
Bring number one piston on compression stroke up to TDC. Drop distributor in so that the rotor points to the number one pin inside the distributor cap. The clamp at the base of the distributor only goes one way so there is no timing with a light necessary, the ECM takes care of that.
Where is number one on a distributor?
It could be any one of the contacts. When the distributor was put in, depending on what type of motor it is, number one could be anywhere. You will need to bring number one cylinder to top dead center on the compression stroke and see where the rotor is pointing. That will be number one and set the rest of the plugs from that.
