0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Difference between gunn diode and pin diode?
gunn diode is transfered electron device & PIN diode is semiconductor device
Is the 2N5777 photo diode an APD or a pin diode?
The 2N5777 is a Darlington silicon NPN photo detector, or, if you prefer a photoDarlington. A link is provided to a bit of data on this device.
Which type of diode used in bridge rectifier?
You can use most diodes for that purpose, and particularly silicon diodes. However, you should not use zener diodes and similar for rectification purposes. Otherwise, you will likely not get the intended result. If the voltage exceeds the avalanche voltage, then the zener diode will no longer rectify, but conduct the other way as well.
What is a real diode?
whether we know that p-n diode is real diode. But still in case of semeconductor we see then silics is real diode.
The bluk resistance of a diode depends on?
Bulk resistance of diode depends on how it is biased. The bulk resistance of a diode is the approximate resistance of the diode when it is forward biased.
Difference between gunn diode and pin diode?
gunn diode is transfered electron device & PIN diode is semiconductor device
Is pin diode and led diode are same?
no
How do you use diode in a sentence?
Example sentence - The little red diode can be used as a pin on a tie.
Has Pin diode depletion layer?
S it has Clinton
How punchthrough risks can be reduced?
A simple way to reduce the punchthrough effect is to increase the overall bulk doping level. As a result the drain and source depletion regions will become smaller.
Why pin diode is used at high frequenc?
Because they work well at high frequencies. Actually, they also work well at low frequencies, but why use an expensive PIN diode when a cheap FET would do.
Fullform of PIN diode?
p-type,intrinsic region and n-type
Is the 2N5777 photo diode an APD or a pin diode?
The 2N5777 is a Darlington silicon NPN photo detector, or, if you prefer a photoDarlington. A link is provided to a bit of data on this device.
My 2000 Nissan Altima has a relay at the ECM How do I check this 4 pin relay 1 and 2 is resistance and 3 and 5 are normal open The socket has a 12 vdc wire?
to properly test relay you must have relay in circuit apply voltage to pin 1 if there is no diode there will not be a polarity issue. if there is a diode you must apply voltage to proper pin or you will have a short circuit. apply ground to pin 2 with coil energized there will be continuity across the other pins when voltage or ground is denied there will be no continuity. to properly test relay you must have relay in circuit apply voltage to pin 1 if there is no diode there will not be a polarity issue. if there is a diode you must apply voltage to proper pin or you will have a short circuit. apply ground to pin 2 with coil energized there will be continuity across the other pins when voltage or ground is denied there will be no continuity.
Why is Avalanche photo diode used when compared to PIN diode?
The output current of a PIN diode is proportional to the light incident . Whereas in APD due to internal multiplication (Avalanche multiplication) of primary photocurrent, higher gains are possible. A small signal current output from the pin diode are to be amplified before applying to next associated receiver circuit. This includes thermal noise in the main signal, giving lower, receiver sensitivity. In case of APD, photocurrent is multiplied before encountering the thermal noise amplifier, giving increased receiver sensitivity.
Why in 8085 36 pin has barr?
Pin 36 on the 8085 is RESET-IN/. There is a bar (/) to indicate that this is a negative logic (low=true) pin. Typically, you connect an RC network to pin 36 (1uF to GND, 75KOhm to Vcc, and small signal diode (1N914) across the capacitor with anode on pin 36) which creates a reset pulse at Vcc power on. The diode is used to force discharge on power off, ensuring a reset sequence when power glitches.
Which type of diode used in bridge rectifier?
You can use most diodes for that purpose, and particularly silicon diodes. However, you should not use zener diodes and similar for rectification purposes. Otherwise, you will likely not get the intended result. If the voltage exceeds the avalanche voltage, then the zener diode will no longer rectify, but conduct the other way as well.
