to properly test relay you must have relay in circuit apply voltage to pin 1 if there is no diode there will not be a polarity issue. if there is a diode you must apply voltage to proper pin or you will have a short circuit. apply ground to pin 2 with coil energized there will be continuity across the other pins when voltage or ground is denied there will be no continuity. to properly test relay you must have relay in circuit apply voltage to pin 1 if there is no diode there will not be a polarity issue. if there is a diode you must apply voltage to proper pin or you will have a short circuit. apply ground to pin 2 with coil energized there will be continuity across the other pins when voltage or ground is denied there will be no continuity.
How do you change the spark plugs in a 1999 Nissan Altima. Can not get socket on the plug.
Axle Nut .. 1994 Nissan Altima ... 36mm socket. You will need a 1/2" Impact or breaker bar. Most parts stores have a loaner program where you can borrower this socket.
16mm
Relax belt by holding automatic belt tensioner with large socket and/or breaker bar
The fuse is located behind a panel located above the hood release. It is called "socket" on the diagram on the panel. I noted, from the Owner's Manual, that the "cigarette lighter" is actually a 12 V outlet, really not intended for a cigarette lighter.
It can't be passed legally but it's about a 30.00 part you can easily change yourself with a special socket
The fuse box panel typically identifies the fuses on the back side (my '01 Max has a sticker on the backside of the panel that shows which fuse is for the lighter).Another suggestion:On a 2008 Nissan Altima, the blown cigarette lighter fuse was located in the driver side panel labeled SOCKET- 15 amps.
it is on front of engine drivers side. real easy to change .use a 10mm socket . it only has i bolt .there is a wiring clip to take off . real easy job
Yep the bulb socket should twist out and then you can repalce the bulb. If you want to replace the whole headlinght assembly then I D.K.
The 1992 Nissan Maxima diagnostic socket location can be found on the bottom of the drivers side dashboard. The diagnostic socket will be to the left of the steering column.
There is a rod that can come loose that connects the throttle cable pulley to the throttle body. When you push on the gas peddal does it feel normal, is there any resistance, or does it feel loose? If it doesn't feel right, you need to reconnect this rod. It has a ball and socket joint that need to be snapped back together.
Snap-on socket # SLEPL 200