0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How can you tell if you have a stuck relay or bad circuit board?
bad relayhow
Were is a dme relay located on a 1985 Porsche 944?
1985 was a changeover year for the 944. Early cars (sometimes refered to as 1985.1, with three separate round guage pods in the dash) have the DME relay located on the relay board in the driver's footwell, under the dashboard. The DME relay is in position 2 of the relay board, second one from the left. Later series cars (1985.5) have the fuse and relay board under the hood, on the left hand side, just in front of the windshield. Open the box up and there should be a diagram on the inside of the lid.
Where is the signal relay on the 1988 cutlass supreme?
You can find it under the dash board.
Where is the wiper relay on a 1992 Nissan Sentra?
I have a 1994 Sentra, and the relay is inside the steering wheel assembly, soldered onto a circuit board.
Where is the fuel pump relay located on the relay board of 91 Volvo 740 gle?
http://www.brickboard.com/FAQ/700-900/ElectricalCircuitsRelays.htm#RelayLocations
Location of the 13-position relay panel on a 1998 VW Beetle?
The relay panel is located under the dash board, above the drivers feet, remove the lower cover panel to access relay box.
Where is the compressor relay on 1984 trams am?
in fuse box,or underneath dash board on passenger side.
Why would the turning signals not work on an Audi A6?
because of the flashers relay in dash board.
What is a relay control panel?
It is the circuit board which has all of the control circuitry and relays mounted for the device.
Can not find turn signal relay?
Relay is under either the hood of vehic or under the driver side clucth peddle or under the dash board on the passenger side
How overload relay works?
An overload relay is fundamentally a board that protects the relay from overloads. It works on the science of being an AC inductor..
How do you tell if your 1998 Audi A4's switch is bad or if it is just a relay?
best way to test a relay is remove it from board, get a 9v square battery and touch the switching terminals on the relay, the relay should click if its working. You can then test resistance through the relay. You can also check the feed to the relay, if theres pwer to the switching terminals on the relay, chances are the switch it ok. If no voltage, switch or wiring.
