It could be any of 100,000 combinations.
The keypad code for your vehicle is specific to your vehicle and your vehicle only. A Ford dealer can reprogram the code if you do not know it.
there's a sticker on the trunk lid with the code on it
Each vehicle with keyless entry has it's own factory code
if you still have the manual it's in there towards the middle.
You will need to take it to a Ford dealership. They will hook up a computer to it and that will give the code.
behind the scuff panel on the left hand side at the drivers feet, there should be a sticker on the junction box with a 5 digit code which should be the keypad entry code.
Hi, You can't replace the factory keypad code. You can add other codes and erase that ones that had been added. You have to replace the module if you don't want the original code to work.
Then you have the wrong code...that can happen if you buy a pre-owned Trac and the previous owner personalizes the code. You can reset your factory set code, directions are in your owner's manual.
Is there an owners manual? It should tell you in there. If not, you might have to take it back to the dealer (any Ford retailer) and have it re-set. Answer The dealer can pull out the factory code which will always be there and work then you can set your on code that you can rember.
You can't miss it, it is located on the exterior of the driver's-side door just below the window.
You will have to get ahold of a ford deal and give them your vin # i believe. I had the same problem when i bought my 2004 ls ;).
If you get on your back and look under the dash on the driver side you will see a computer module with a white sticker with the factory code on it. Enter that code and you will be able to reset it to your code. answer below is someone elses suggestionYou first have to get the Manufacturers code from a Ford dealer at a cost of about $40.00. Then you need to enter that code to reset the keypad , then you can enter your own code. hope this helps. Jack