Sound power or sound intensity I is a sound energy quantity.
Sound pressure p is a sound field quantity.
Sound intensity is sound pressure squared. I = p².
See related link.
Sound power level is equal to sound pressure level and intensity level at a distance of r = 0.2821 m from the source at full sphere propagation. See related Link.
Compare Sound power, Sound pressure, and Sound intensity. All share as level the same unit of measure: the decibel (dB). The term "sound level" is commonly substituted for each. As characteristic impedance of air we use the round value Z = 400 N·s/m³ (Pa·s/m). Then the "sound level", that is the sound pressure level Lp and the sound intensity level LI is exactly the same as a decibel value. The sound power or acoustic power is the sound energy constantly transferred per second from the sound source. A sound source has a given constant sound power that does not change if it is placed in a different room environment. Sound power is a theoretical value that is not measurable. It is calculated and expressed in watts and as sound power level LW in decibels. A sound source produces sound power and this generates a sound pressure fluctuation in the air. Sound power is the distance independent cause of this, whereas sound pressure is the distant-dependent effect.
The most probable difference between the two: 1. Device - does not consume power 2. Appliance - consumes power
12 volts is less of power than 18 volts drill
pVO2 max = power at VO2 max. I think it's the power output (in watts) that is generated while cycling at VO2 max
The commerical microwave has more power then a regular microwave which has a smaller level of power.
High pressure line gets very hot.
Trim level such as the interior, power windows seats ect.
Sound power level is equal to sound pressure level and intensity level at a distance of r = 0.2821 m from the source at full sphere propagation. See related Link.
What the difference between process piping and power piping?
Power supply: Water pump, producing pressure at its output valve.Resistor: A section of pipe. Flow of water loses energy on the way through, due to friction with the pipe's interior wall.Potential difference: Difference in water pressure between the beginning and end of the pipe section.
Helpful. What you call "power lines 1 level 6", it has to make 10 and there are six powercells. What you call "power lines 2 level 7" is has to make 21 and there are more than six which is 9 powerce.
It's the difference between pressure and flow. The pressure is measured in volts, and the current in amps.Current is the flow of electrons.Power=VIcosϕV=voltageI=currentCosϕ=cosine of angle between V and IAnswerCurrent is a drift of electric charge, expressed in amperes. Power is the rate of doing work, expressed in watts (equivalent to a joule per second).
A force over an area produced by a pressure difference
The objective of political parties is to attain power and form the government, whereas the aim of pressure groups is only to influence the decision-making of the government
Yes. The height of the water level above the turbine affects the water pressure, and therefore the amount of power that can be generated.
help!