Want this question answered?
20nm 40nm 90degrees 90degrees
30nm 90degrees and then another 90degrees
Uno 1100 cylinder head? 30nm 90degrees then another 90 degrees
Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.
Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.
The torque settings for a 96 Fiat Punto 12cc for cylinder head bolts are 30 NM at 90 degrees. Then an additional 90 degrees.?æ?æ
8-10Nm
Q
What is the mains and big end bearings torque setting for uno 1100 engine
You have not told us for what bolt or nut ?. There will be almost a whole page of torque settings for that vehicle. Oilpan bolts may be as little as 12 while cylinder head bolts will be around 70 . We have no clue unless you name the bolt.
The starter motor is located at the back of the cylinder block on the right hand side
Punto 1.2 engine code 176A7.000 Torque Stage 1. 20Nm Stage 2. 30Nm Stage 3. + 90 degrees Stage 4. + 90 degrees.