0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What size bolt hold the Harmoic balancer on a 1993 Jeep Cherokee?
The bolt on my 1994 jeep Cherokee is a 19 mm. I don't know if it's the same, but i bet it is.
What is the torque Specification for the harmonic balancer bolt on a 94 Toyota truck?
120
Chevrolet 350 harmonic balancer bolt torque?
60 ft-lbs
Can you tighten a harmonic balancer to tight on a Oldsmobile cutlass?
You can tighten ANYTHING too tight. EVERY bolt and screw has a specific torque specification. Look up what the torque specs are for the balancer bolt on your engine and tighten it to the specification.
How do you take the harmoic blancer off a 97 breeze?
You will need a three prong puller and a 7 or 8 inch bolt, no thicker than about 5/16. Remove the balancer bolt, insert your thinner bolt (the bolt needs to be long enough to stick out atleast an inch). Then hook your puller on to the balancer and center the puller bolt against the head of your guide bolt. Should come off pretty easily.
Torque spec on harmonic balancer bolt on v8 350 eng?
The torque specification, for the harmonic balancer on your 350 cubic inch engine, is 280 pounds per square inch. The torque specification may vary according to the manufacturer of the engine.
Torque settings for v6 commodore vs 1997?
Torque Setting for VS Commodore Harmonic Balancer Bolt- between 270-320 NM. The Best way is to check the bolt torque setting before you remove it.
How do you replace harmonic balancer on 1993 f 350 with 351 motor?
first remove serpintine? fan belt then remove large bolt in middle of harmonic balance. this bolt usually has left hand thread next with a harmonic pulley ,puller, remove harmonic balancer.when removing this, there is a key in the balancer and shaft if a new key did not come with new balancer,make sure not to loose the old one install new balancer with key.use the bolt to pull balancer up tight where it needs to be and use proper torque on bolt
What is the torque on the bolt that holds the harmonic balancer on a 63 Buick Skylark 215 cu in V8?
140-160 ft lbs
How do you install a harmonic balancer on a 1999 Chevy Silverado with a 5.3?
The engine has a harmonic balancer on it, but if it is off, it is easy to re-install. Simply line up the key and tap it on most of the way and torque down the center bolt.
Impact wrench 250 pounds max torque won't budge Harm Balancer Bolt Any suggestions?
Borrow a bigger impact wrench, something with at least 500 ft lbs of torque.
What is the torque specification for harmonic balancer bolt for a 1998 Dodge Ram 1500 5.9 liter V8?
between 150-180. anywhere in that area is fine
