Want this question answered?
front min spec is 30.08mm rear min spec is9mm
3
8mm
front rotors are 25mm standard min is 22mm back rotors are 8.5mm min
I am in CA, so don't know about other states, but here it is required to have at least 2 handicap parking spaces in the parking lot. There may be additional parking, but that could be based on population size of the company, but the min. is 2.
In order to calculate a production line efficiency you need to obtain data of the number of pieces and the number of hours worked. In addition, you will also need to obtain the piece/min data by conducting a time study at the front and end of line (ensure that they are equal). Following the collection of this data you can approach it in this manner: Number of pieces total / number of minutes of production= Avg. pieces per min Now... take your (Avg pieces per min/actual piece per min count) x 100= efficiency percentage OR actual piece per min ratex number of actual production minutes = total estimated pieces now....(total actual pieces/total estimated) x 100= efficiency percentage
min rotor spec is 26.0mm
No, you should get 30 + 2-10's.
0.870 Min. discard thickness
Min. compact car stalls...need to be at least 7 feet 6 inches wide.
An electric kettle, rated at 1.5 kW, heats 1.1 kg of water from 14°C to 99°C in 4 min 45 s. Determine the efficiency of this application of an energy
There is a drain line for the sun roof that travels through the roof pillar and connects to a 90 degree elbow fitting on the driver's side behind the panel that covers the parking brake, (very difficult to see), and on the passanger side behind the panel for the fuse box. This drain line seems to shrink over time and pulls out of the 90 degree elbow. Drivers's side takes about 60 min to reconnect because of the parking brake and needing to remove the hood release. Passanger side is much easier.