0
What else can I help you with?
Where is the fuel pump located on the 1989 vn Holden commodore executive?
Inside the fuel tank, you access it from the front side of the fuel tank
Where is the coolant sensor located on a 1989 Chevy 350 tbi?
The 1989 Chevrolet 350 cubic inch engine coolant sensor is located on the front of the engine. The coolant sensor will be near the thermostat housing.
Where is the cam shaft sensor on a 1989 Oldsmobile 88?
in the intake where the dist. should be on the front of the engine
1989 Oldsmobile delta 88 crankshaft sensor location?
The Crankshaft sensor is located behind the Harmonic Balancer on the front-passenger side
Where is engine coolant temperature sensor on 1989 blazer?
Next to the water neck on the front of the intake manifold.
Where do you find the knock sensor on a 1989 gm sierra truck?
As you are looking at your truck from the front the knock sensor shoud be on the passenger side right under the manifolds
Where is the oxygen sensor located in a 1989 cadillac deville?
on the exhaust just in front of the catalytic convertor. Good luck
Where is the crankshaft sensor on a 1989 Buick Regal 2.8 V6 and how do you replace it?
at the front of the engine,next to the harmonic balancer
Where is the cold start sensor time switch on 1989 Toyota land cruiser?
The cold start sensor is the top sensor on the right side of the thermostat housing as you are looking at the engine from the front of the vehicle. It is 22mm.
Where is the sensor located for the outside temperature on a 1989 Cavalier Z24 with digital instrument package?
in the front,by the grille and the front end,open the hood,look right under the front end piece
Where is the cam sensor on a 1989 dodge cummins?
A 1989 5.9L Cummins does not have a cam sensor.
How do you replace the crankshaft positioning sensor on a 1989 ford sho Taurus?
To replace the crankshaft positioning sensor on a 1989 Ford Sho Taurus, go near the water pump at the front of the car and remove components that block access to the sensor. Remove the two bolts holding the sensor in place remove the wire that sends data. Finally, replace the crankshaft positioning sensor.
