0
I(per Phase)=4000/(230*3) = 5.8A
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How many watts in 1 ampere 230 volt?
Watts = Amps X Volts Grab your calculator!
Can you run single phase 230 from one side of 480 volt 3 phase?
No, you will not obtain 230 volts. From a wye connected three phase 480 volt supply, 277 volts can be obtained from one phase leg and the neutral on the wye connection. 480 volts/1.73 (sq. root of 3) = 277 volts.
How much is 900 watts?
About as much as 15 typical (60watt each) light bulbs together. Or expressed in horsepower: about 1.2Hp Mains volts and ampere: 230 volt at 3.91 ampere = 900watt 110 volt at 8.18 ampere = 900watt
If 5000 watts operates 230 volts three phase what will it draw in amps?
21.739 a 21.739 a
Does common wire act as ground when hooking up 230 volts single phase?
Not always
Why is mains voltage 230V?
Yes 230 volts is classed as single phase but it is not the only single phase voltage. If you take any two legs from a three phase system, the voltage from these legs is also classed as single phase. The 230 volt single phase is the output of a transformer whose primary is one leg of a three phase primary high voltage system. The 230 volt secondary is center tapped to give 115 volts before the tap and 115 volts after the tap, hence the common voltage of 115/230 that is used in North America.
What is the household AC electrical power mains voltage in Europe?
in Australia most homes are single phase 240 volts but when measured with a multi meter sometimes you get readings of between 230 and 250 volts
Well Pump Installation?
form_title=Well Pump Installation form_header=12353 Are you in need of single or three phase power?*= () Single phase () Three phase () Don't Know Do you know the voltage of you power supply?*= () 155 volts () 208 volts () 230 volts () 460 volts () Don't Know () Other
What is max single phase hp as per nec?
The maximum single phase HP motor listed in the CEC is 10 HP. At 115 volts 100 amps and 230 volts 50 amps.
How do you obtain a 230 volts single phase supply from a 400 volts three phase four wire supply?
400 volt three phase on a grounded system is 230 volt single phase, with each phase 120 degrees apart. So, if you have a 400 volt, three phase four wire service (grounded service), you can pull one phase off and reference to the neutral for 230 volt service. Note this may not allow 115 volt service, unless there is also a center tap for each phase.
What happens if you cross your 230 volts single phase wires?
Nothing, the equipment will still run the same.Because this is a AC voltage
How much current would a 5-kW heater draw with 230 volts?
The formula you are looking for is I = W/E, Amps = Watts/Volts. Amps = 5000/230 =21.7 amps. The wire size to run this heater would be a #10 copper conductor. The supply breaker would be a two pole 30 amp breaker.
