The bar is called the sway bar take it of and replace it.
The general location is on the passenger side between the front tire and front bumper.
how do I take apart the front suspension for the jounce bumper
As you look at the car from the front, it will be behind the bumper cover on the left. You must remove the entire bumper to access it.
what year was the first car bumper made? around 1895 they came out with the horsecarrige and on it was a bumper so sometime around.
About 20 years.
the bumper and grill comes off as one, with two screws where it connects to the fenders, five plugs for the grill and two plugs on bumper. Pull it off and four 10's -two on top, one on inside towards where grill was, and one that connects to the fender.
Well...it depends. A Regular Beetle (flat windshield, no slots in the apron under the front bumper, spare tire upright, steel dashboard) has no springs in either end of the suspension. A Super Beetle (curved windshield, slots in the front apron, spare tire lying flat, plastic dashboard) has McPherson Strut front suspension with springs around the shocks, but no springs in the rear suspension.
its a series of screws and bolts.. its really easy.. first the two screws on each side of the wheel well where it meets with the fenders on each side of the car.. second take the bumper lights out with the single screw either on the inside or outside (i forget).. pull out the the bumper lights and take out the lights from the light sockets on the bumper lights.. third behind the bumper lights is where the bumper support bolts on to the frame.. its alot easier if you take of the bumper support with it.. they're two 12mm bolts one on top the otherbehind each bumper light.. take off all four.. then the bumper will hang loose.. on the bottom of the bumper will be two 10mm bolts where the bumper connects to the radiator support.. take those off as well.. and voualla.. (how ever u spell it) the bumper is off when replacing any front end piece (besides the hood) it is always good to take off the front bumper.. i found out the hard way when i tried to replace my filler panel (between bumper and head light)
The average price for a bumper protector for a BMW sedan is usually around $100. One can purchase this bumper protector at the online site "Eurobumperguard".
For us, we had a problem with the front bumper so I guess the back should be the same. The dealer was charging us around $1000 for a new bumper and labor. Online sites showed the bumper for around $300. I ended up doing it myself and saving $700.
it is behind the right headlight. you can see it from the wheel well in front of the tire just behind the bumper
The average price for a bumper protector for a BMW sedan is usually around $100. One can purchase this bumper protector at the online site "Eurobumperguard".