What is the black piece called that connects the radiator hose that goes into the block and holds the hose in place?

One of the hoses that connects the engine block to the radiator.

Follow the top radiator hose back to the engine block. The thermostat is inside the housing where the radiator hose connects to the block.

this is the part where the top radiator hose connects to on the block

The thermostat for the 3.5 Liter is under a flange bolted to the top of the block (in the valley), connected to it is a black pipe that connects to the lower radiator hose. This flange has four bolts that are accessed only after removing the intake manifold. Removing the housing that connects to the upper radiator housing optional.

Follow the UPPER radiator hose from the radiator to where it connects to the engine block. The thermostat should be right there.

located at the block where the top radiator hose connects to it.

It is located at the lower radiator hose where it connects with the block.

The black radiator hose comes out of the upper left of the radiator. Follow it to where it connects to the engine block at the top center of the engine. It is just to the left of the ignition coil. That is the thermostat housing. Remove the bolts holding the housing, and the thermostat will be there.

Under the fitting where the top radiator hose connects to the engine block.

Follow the top radiator hose back to the engine block. The thermostat is usually behind the housing that connects the radiator hose to the engine block. To be more specific Its on a housing on the passenger side of the engine block.

Find top hose on the radiator. Follow the hose to the engine block. Where the hose connects to the engine block, the thermo is right there.

Where the big radiator hose connects to the front of the block.

It is located on the top radiator line where it connects to the block. There should be 2 bolts that secure it to the block.

Look at the radiator. Follow the large coolant hose that comes out of the top of the radiator and follow it down to where it connects to the engine block. The housing that the hose connects to on the engine contains the thermostat.

Follow the upper radiator hose from the radiator to the engine block. The point where the hose connects to the engine is where the thermostat is typically located.

a 4.5L 273 cu in. it's located on the exhaust manifold, in front in between the block and the radiator. You'll see the wire that connects to it. a 4.5L 273 cu in. it's located on the exhaust manifold, in front in between the block and the radiator. You'll see the wire that connects to it.

Where the lower radiator hose connects to the engine block.

inside the thermostat housing where the lower radiator hose connects to the engine block.

if you have a 3.3l v6, then you follow the upper radiator hose to where it connects to the block. It's around the throttle. The place where the hose connects can be removed, and the thermostat is in there.

Most thermostats are in-line with the upper radiator hose. Check the housing where the upper radiator hose connects to the block.

It is located in the thermostat housing where the lower radiator hose connects to the engine block.

On my 1995 Ford Explorer the lower radiator hose connects to the waterpump on my 4.0 liter OHV , V6 engine ( the 8th " character " of the VIN is an " X " )

Take the 4 bolts out of housing on the right front side of engine where you lower radiator hose connects to the block and the hose that runs down from the radiator tank .

Follow the upper radiator hose back to the engine the point at which the upper radiator hose connects should be a block on the engine held on with either 2 or 3 bolts thermostat should be inside the block. BTW what engine.

Where the upper radiator hose connects to the engine the thermostat is located under the neck protruding from the block.

The thermostat is located in the housing where the upper radiator hose connects to the engine block.

It is located on the engine block where the upper radiator hose connects to the engine. To get at it you need to remove the serpentine belt and alternator.

Follow the bottom hose comming from your radiator to where it connects to the engine block, u will see the housing that normally looks like it sits on top of the block, the thermostat is located inside this housing. its inside the bottom hose of the radiator, not the top.

The thermostat is 7 inches to the left from the headers. You will notice it on your motor, as a metal pipe that protrudes up with a bolt/opening before it meets the block. You can also follow the black radiator, the most noticeable one on top to the block and will see the thermostat right before it meets the block as stated up there. on the back side of the motor where the lower radiator…

Follow the top radiator hose back to the engine block. There is usually a housing where the hose connects to the engine block. Thermostats are usually under that houshing, or in some cases, the housing IS the thermostat.

Mazda did make a 1993 b2300(it was a b2200 or b2600).However the answer is follow the upper radiator hose to the block near the valve cover.The upper radiator hose connects to the thermostat housing.Easy.

The thermostat is inside the small housing where the top radiator hose connects to the engine block.

It is located on the engine block where the upper radiator hose connects to the engine. To get at it you need to remove the serpentine belt and alternator.

It is on the upper right of the engine. Find the upper radiator hose at the top right (drivers side) of the radiator, then follow it towards the engine. When you find the end of it, this is where the thermostat sits. Under a small metal block that the hose connects to and the block is bolted with 3 bolts to the motor.

Follow the top radiator hose back to the engine. The thermostat is behind the housing that connects the top hose to the engine block.

It is bolted to the engine block. There are 2 large hoses connected to the radiator. One is on the top of the radiator and the other is at the bottom. The bottom hose connects to the thermostat housing which contains the thermostat inside of it as one piece.

A water pump? In all vehicles that I've had and know of. Your radiator has an intake and an outtake, Your intake goes from the radiator, to the thermostat, the thermostat connects usually directly to the water pump or only has a few inch distance from that.. It circulates the coolant around / in the block. and feeds it out of the block usually on the opposite side, it registers on your vehicles thermometer (the…

on the right side of the engine block you will see a plastic black housing its in there just follow the radiator hose on the top right side of radiator

There are two hoses that connect the radiator to the engine block. On older cars, the thermostat would be where the top hose connects - ie where it is easy and convenient to get at, etc. Unfortunately, on your car the thermostat is located where the bottom radiator attaches to the engine block - closer to the firewall, under the breather, etc, where it is a total pain in the ass to get to.

follow your lower radiator hose to where it connects to the engine block remove that hose and there u go thermostat will be inside the thermostat housing right underneath

There are 3 different motors listed for the 87 E150 Ford van. The 4.9 the 5.0 and the 5.8 all have the thermostat located where the top radiator connects to the motor in the housing that the hose connects to. It will be under the inlet on top of the engine block.

The Haynes manual I have says the thermostat housing is located between the lower radiator hose and the block on the left front side of the engine. The thermostat and housing are all one piece. The lower radiator hose (return) connects to the thermostat housing. follow the out hose for the rad until it enter the block it shouldn't be hard to find.

Its called the LOWER hose for a reason. It goes from the bottom of the radiator to the lower front of the engine. It's a black, round rubber tube. The radiator is the thing at the front where the green water goes in. The engine is the noisy hot metal thing under the hood. The hood is the big metal plate in front of the windshield...

Yes it is on the lower radiator hose where it connects into the engine block, follow that disconnect it (careful of coolant leaking) thermostat housing should be below that hose. Good luck

If the engine is a 2-stroke you can see a small black block under the gold plated screw that connects the fuel cable to the carb. Saw it off.

It is somewhere in the cooling system. It varies by make and model. On most vehicles, the thermostat is located by the block. where the radiator hose connects to the block. Again it varies by year, make and model. Next time asking a question state the Year, make and model of the vehicle.

If you're talking about a battery... The + is positive, sometimes red, and connects to something with power such as your alternator. The - is negative, sometimes black, and connects to the ground such as the block or chassis.

On the front side of engine, follow the lower radiator hose down to block. It's in the black plastic housing.

ITS EASY FIND YOUR TOP RADIATOR HOSE IT WILL RUN DOWN INTO UR BLOCK BY THE WATER PUMP. IT CONNECTS TO A NECK THERS 2 BOLTS HOLDING THE NECK ON TAKE THOSE OF THEN POP THE NECK OF THE BLOCK YOURE THERMOSTATE WILL BE SETTING RIGHT THERE UNDER IT

if you are looking at the motor it is on the right hand side where the radiator hose connects to the block. It will be under the hose connection. Takes two 10mm bolts . new t-stat comes with gasket.