153552313
5x114.3
See the following website for details... it depends on the year.www.discountedwheelwarehouse.com/Mazda___Vehicle_Bolt_Pattern_
On the back of the caliper there should be a bolt its a 14mm you take it out and inside there is a bolt also its Allen key you use and Allen key and retract the caliper. it works on all 626 from 1994 till 2002
The head bolt torque specifications, on your Mazda 626, is 120 pounds per square inch. The head bolts should be torqued in 40 pound intervals.
From recent experience, the Alternator belt. It is easily tightened by loosening the top bolt and tightening the horizontal adjustment bolt.
To change the alternator belt on a 1998 Mazda 626 you need to first loosen the bolt that is located in the center of the adjustment pulley. Next, turn the adjustment bolt to the left until the belt is loose and can be removed. Reverse the steps to replace with the new belt.
if it is what i think it is there is a nut that you put a bolt in that pulls the sump down
Each motor mount is held in place by a retaining bolt. The retaining bolt goes through the middle of the motor mount. Remove the retaining bolt. Jack the engine up. Replace the motor mount.
It's a standard thread not reverse threaded. Same with the automatics flex plate bolt and manual transmission's pressure plate bolts.
23 percent of 626 = 143.9823% of 626= 23% * 626= 0.23 * 626= 143.98
Identical down to the metric bolts, screws and fuses.
try taking the bolt out for the motor mount on that side where alternator is and jacking the motor up.