Some vehicles are equipped with a low brake fluid level light that is nothing more then an electric float device mounted in the master cylinder brake fluid resevoir, when the brake fluid drops to a certain level the float drops also setting off an electric sensor warning light telling the driver of the vehicle a possible problem may be taking place in the braking system of the vehicle.
Check the condition of all four brakes look for any brake fluid leaks at the wheel cylinders, brake lines, master cylinder etc. if all is ok fill the master cylinder to its proper fill line and the light should go out.
NEW ANSWER: I believe the question was a brake light problem.
If you are SURE the brake light switch on the pedal is good then you need to check all the GROUNDS in the brake light wiring harness and the grounds in the rear brake light sockets. If those things check out okay, Then your brake light problem is most likely the multifunction switch in the steering column.
It would have been NICE to have known what YEAR and type that you are working on.
Above the brake pedal. If your main brake lights dont work but your third center brake light does, then the brake light switch is not the problem. Its is the turn signal switch.
Perhaps the bulb is bad?
The brake light switch on a Nissan is located just behind the brake pedal. It sends a signal to the brake lights when the pedal is pressed to turn them on.
the switch is on top back side of brake pedal.
brake light switch is above the brake pedal
THE BRAKE LIGHT IS LOCATED BELOW THE DASH. LOCATE THE ARM HOLDING THE BRAKE PEDAL AND YOU WILL SEE A SWITCH THAT COMES OUT WHEN THE PEDAL IS DEPRESSED TURNING THE LIGHT ON. WHEN THE BRAKE IS RELEASED THE SWITCH DEPRESSES AGAIN TURNING THE LIGHT OFF.
It is just above the brake pedal. The switch rests against the brake pedal lever.
check brake light fuse and brake light switch on pedal
The brake light switch is behind the brake pedal.
The brake light switch is on a bracket just above the brake pedal.
the brake light switch is on a bracket just above the brake pedal.
There's a switch on the brake pedal that when you step on it, it completes the circuit for lighting up the brake light.