answersLogoWhite

0


Best Answer

The brake rotor specs for 93 Toyota corolla the outside diameter 255 mm and inside diameter is 142.2 mm.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the brake rotor specs for 93 Toyota corolla?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the torque specs on head gaskets for 1988 Toyota corolla?

torque specs on head gaskets 1988 toyota corolla 4A-F


What is the length of a 1994 Toyota Corolla?

4.275m See http://www.cars-directory.net/specs/toyota/corolla/1994_5/2387/


How much does a Toyota Corolla weight?

Toyota Corolla does weights about (depends on a model and specs) 2,822 lbs or 1280 kilos.


Wheel bearing torque specs 2003 Toyota Corolla?

216 nm


What are the timing specs for a 1998 Toyota Corolla?

no timing spec at all due to used timing chain.


What are the brake rotor discard specs for a 1988 Oldsmobile cutlass supreme with 4 wheel dics brakes?

The minimum thickness specs are stamped into the rotors.


What is the torque specs of a Toyota corolla 1.3L 2E engine?

There are torque specifications for every bolt in a Toyota Corolla 1.3 L engine. The head bolt torque specifications is 70 pounds.


What is the minimum rotor thickness of the rear brake rotors on a 2003 gmc sierra 1500?

If you clean the rotor up alittle you will see it STAMPED on the rotor. Look at it and you will find it. That will be factory specs. If your smart, you will REPLACE the rotors and pads and you will have done a good brake job.


What is the torque specs on a Toyota corolla cam head bolts?

Look in a Haynes repair manual relative to your vehicle i do not have any manual


What are the torque specs on a Toyota Corolla 1.6 lt engine cylinder head?

The Toyota Corolla 1.6 liter engine cylinder head bolt torque specification is 150 pounds. The head bolts should be torqued in 50 pound intervals.


How do you know when the front rotor on a 1995 Honda Accord is bad?

A bad brake rotor in the front or rear can cause a pulsation in the brake pedal when pressure is applied on the brake pedal when the vehicle is in motion. The brake rotor can be measured with a micrometer to be sure it is within specs and has enough material to be legally resurfaced on a brake lathe. In most cases now rotors are simply replaced with new ones to be cost effective.


Specifications 1998 Buick Park Ave rear brake rotor?

Specs 98 Buick Park Ave rear pads