Want this question answered?
i know, burnt it.
The key code will be in one of two spots. The first location will be behind the ignition switch, etched into the black metal housing; think between the ignition switch and front fairing. If you do not see your code there, the lower end of your ignition switch will list this code. With a flashlight and your handlebars turned all the way to the left you can read the key code from looking at the ignition switch from the bottom right of the bike. This info was for a ninja 250/500 since you did not specify
The 1980 Suzuki key code switch is located near the ignition switch. This is the common location for most older models.
Trouble code P1682 means: Ignition 1 Switch Circuit 2
On original key knock out and on the side of the ignition switch.
I don't think you can bypass them.
97-98 Mark VIII's have a computer chip in the key head that is read by the ring around the ignition switch. The key must be programmed to the ignition switch by the Ford or L/M dealer. They will also be able to get the key code for you upon verification of your ownership of the vehicle.
turn your ignition switch off and then on in rapid sucession four times dash lights will blink and code can be reset
look under the petrol tank for a sticker.on this will be codes one of which is the paint code write all down and wit this info goto www.banditmania. .they have all the paint codes for bandits.hope thic helps
The ignition wire in a Nissan 350z is black and red. The starter wire is white/red and the second starter wire is white/green.
There is no hex color code for a transparent or colorless color because there is no such color as transparent. Transparent is whatever color the backdrop is. Thus, there is an almost indefinite number of colors that could be considered feasibly transparent... but are not transparent. In other words, there needs to be a "transparent" option to switch any electronic color code setting to transparent.
Switch the ignition to "accessories" or "acc" (turn the key 1 click in the ignition) with "err" displaying on the radio, leave the key in the ingnition for 1-3 hours. "err" should now be replaced with "code" allowing you to enter the correct code a and unlock the radio