0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you repair drum brake on 1994 gmc sierra?
Brake drums can be resurfaced by turning the brake drum in a brake drum lathe. When the brake drum has deep grooves in it, it cannot be repaired.
What is the function of a drum brake?
A drum brake is a brake that uses friction caused by a set of shoes or pads that press against a rotating drum-shaped part called a brake drum. The term drum brake usually means a brake in which shoes press on the inner surface of the drum.
What is the function of a drum?
A drum brake is a brake that uses friction caused by a set of shoes or pads that press against a rotating drum-shaped part called a brake drum. The term drum brake usually means a brake in which shoes press on the inner surface of the drum.
What are the two main components of the drum brake system?
The drum and the brake shoes.
In what situation is drum brake better than disc brake?
In case of cost..drum brake is better than disc brake.
What is the purpose of a drum brake?
The purpose of a drum brake is to come to a complete stop with any veichle that may have drum brakes in the rear of the car.
Is there something holding rear brake drum on 1994 caviler what holds rear brake drum on 1994 cavalier after removing tire?
how to remove rear brake drum on 1994 cavalier
How do you remove front brake drum on kawasaki mule 2500?
You can remove the front brake drum, on your Kawasaki Mule 2500, by removing the wheel and axle. The brake drum will slide off.
How do you remove brake drum on 1991 Mazda 323?
how do remove the brake drum on a 1991 mazda 323
Remove a rusty rear brake drum on a 1975 corvette?
Better hope it is not a drum brake- it was originally equipped with a disc brake caliper.
Does the 1993 Camry have rear brake pads?
Take the wheel off to see if you see a caliper for a disc brake or a drum for a drum brake.
Why do you turn or reface a brake drum?
Normally a brake drum is turned or resurfaced using a brake drum lathe. This is usually done at a shop specializing in brake repair, or at a machine shop. Those who have a suitable metal lathe can also turn brake drums.
