0
What is the correct screw driver head and size for Jeep Liberty tail light assembly bolts?
Wiki User
∙ 18y ago
TORX T-15
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you replace headlight bulb on the driver's side in the 2002 Chrysler sebring?
I'm assuming you have a convertible since from what I've read, the sedan bulb replacement is very straightforward. To replace the bulb in a convertible you need to remove the headlight assembly by removing 2 bolts, one near each end of the assembly. These are (I believe) 8mm bolts so don't go removing the larger ones. Once the bolts are out you can remove the assembly. Remove retaining ring, pull bulb assembly out and unplug the bulb. Reverse directions for re-installation.
1995 Honda Accord headlight assembly replacement instructions?
Open the hood to the engine compartment. Remove the headlight wiring harness. Remove the headlight assembly bolts. There are four headlight assembly bolts. The headlight assembly will come out.
Do you need to remove the bumper to replace the driver's side headlight assembly on the 1998 Volvo S70?
No you do not, there are 3 bolts you need to remove in order to take out the headlight. Don't remember off the top of my head where they are located but you should see them. I think they are 12mm bolts.
How do you change the wheel bolts on a Oldsmobile regency 98?
you have to replace the wheel bearing hub assembly look up a picture and you will see the bolts are attached to the hub assembly.
How do you remove door lock assy on the driver side of a mercedez Benz 190 E?
Remove the drivers side door panel of your Mercedes-Benz. Remove the door lock assembly retaining bolts. Remove the door lock linkage. The door lock assembly will come off.
How do you install Driver Side Mirror on Hyundai Elantra 2002?
Pop off the plastic cover on the inside of the door, opposite the mirror. There are just a few bolts to unscrew, and a wire to unplug, and then the entire assembly just pops off. Pop off the plastic cover on the inside of the door, opposite the mirror. There are just a few bolts to unscrew, and a wire to unplug, and then the entire assembly just pops off.
How do you replace the thermostat in a 1993 Lincoln Mark VIII?
put it up on ramps or jack up the driver's side front wheel. the thermostat is found in a small assembly on the driver's side in front of the motor. it has three to four coolant hoses attached to it and three bolts to take it apart.
Headlight assembly removal 2002 Honda accord?
Remove the wiring harness from the back of the headlight. Remove the headlight assembly bolts. The headlight assembly will come out.
1994 Saturn S-2 you need to replace the driver side mirror It looks like you need a special tool to do this you know there are three bolts holding this But there also appears to be some type of screw?
The bolts you see are part of the exterior mirror assembly. All it takes is removing the 3 nuts.
Where are caliper bolts on 2004 Jeep Grand Cherokee front caliper?
They are the two long bolts covered by a rubber boot. They also act as a guide/slide pin so the assembly can move to clamp the rotor. Do these bolts connect to a larger assembly behind the rotor?
How do you replace front wheel bearing assembly on dodge stratus?
The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.
98 Lincoln Continental belt tensioner assembly removal?
The 1998 Lincoln Continental belt tensioner assembly is held in place by three retaining bolts. Remove the retaining bolts. The belt tensioner will come off.
