Go to www.inthezone.com and u can get ur answer there.
A replacement part for a 2002 Ford Ranger oil pan gasket will cost a price close to $40. The part can be purchased from a auto parts store.
Maybe $100. You might be able to do it yourself for the cost of the gasket and the 2 hours it'll take to drain oil, pull pan, clean old gasket areas then apply new gasket and reinstall the pan.
The approximate cost to change an oil pan gasket, on your Ford Taurus, is $125. The oil pan gasket can be purchased for $10.
To change the oil pan gasket on a 1994 Ford Ranger 4x4 with a 4.0L V6, first, safely lift and support the vehicle. Drain the engine oil and remove the oil pan by unbolting it from the engine block; you may need to remove other components like the exhaust or crossmember for access. Clean the mating surfaces thoroughly, install the new gasket, and reassemble the oil pan, ensuring all bolts are torqued to the manufacturer's specifications. Finally, refill the engine with oil and check for leaks.
If it the gasket on the oil pan leaking, it would cost approximately $450 to have the oil pan removed and the gasket replaced.
If the gasket is replaced by you, then the only cost would be the replacement gaskets which do not cost much.
you have to pull the engine.
It can run between $30 and $60 to replace the oil pan housing for this car. It all depends on where the part is bought, and who does the replacing.
You don't say where it is leaking oil from. Kind of hard to offer suggestions on how to repair. Could be oil pan cracked or loose, oil pan gasket, oil filter gasket, oil filter loose or cracked; valve cover gasket, etc. Is it smoking? Please give more detail.
Drop the lower transmission pan Clean pan Replace filter and gasket
To change the transmission pan gasket on a 1994 Plymouth Acclaim, first, ensure the vehicle is on a level surface and securely raise it using jack stands. Remove the transmission pan bolts and carefully lower the pan to avoid spilling fluid. Clean the mating surfaces of the pan and transmission, then place the new gasket in position. Reattach the pan, tightening the bolts to the manufacturer's specifications, and refill the transmission fluid as needed.
It should be located in the oil pan. On my ranger its on the drivers side.